LAMAX Base2 Wireless Headphone User Guide

LAMAX Base2 Wireless Headphone

Controls

Power on	Move up to Power on position
Power off	Move up to Power off position
Play / Pause	Press
Next track	Hold for 2 seconds
Previous track	Hold for 2 seconds
Volume up	Press
Volume down	Press
Answer / End call	Press
Reject Call	Hold for 2 seconds
Activate mobile assistant	Double press

Power On

To turn the headphones on, slide up to the Power on position. Switching on is accompanied by an audible notification and a blue-red flashing indicator LED.

Power Off

To turn the headphones off, slide down to the Power off position. Switching off is accompanied by an audible alert and the LED goes off.

Pairing

1. The headphones automatically go into pairing mode the first time you turn them on. This is indicated by the LED alternately flashing red and blue.
2. On your device, turn Bluetooth on and locate and select LAMAX Base2 in the list of available Bluetooth devices. After successfully pairing, there is an audible notification and the blue flashing LED.

If you have problems with pairing, remove the headphones from the list of paired devices on your phone. Hold for 6 seconds. Then pair as described in step 1.

Charging

To charge, plug the USB-C cable into the headphones, then plug the other end of the cable into a USB charger with a maximum voltage of 5V. The LED will glow red when charging, after a full charge the LED will turn off.

Parameters

Wireless technology Bluetooth 5.3
Bluetooth range up to 15 metres
Supported codecs AAC, SBC
Battery capacity 500 mAh
Headphone charging time 2,5 hours
Playback time up to 48 hours
Weight 220 g

Printing errors reserved.
The latest version of the user guide can be downloaded here:
https://lamax-electronics.com/base2/manual