VAULT AI-PRO-IP Mounting Component For Tablet

Models

• 11″ Enclosure
  
• 12.9″ Enclosure
  

PARTS INCLUDED

• Faceplate
  (1)
  
• Backplate
  (1)
  
• Rubber Spacer
  (6)
  

PRO-IP11 ENCLOSURE HARDWARE PACK

• 10-32×1/2
  Flat Head
  (4)
  
• 6-32×1/2
  Flat Head
  (2)
  

PRO-IP12 ENCLOSURE HARDWARE PACK

• 10-32×1/2
  Flat Head
  (6)
  

PREASSEMBLY

Insert rubber spacer into specified locations.

• 12.9″ iPad Pro
• 11″ iPad Pro – Place In location 2
• 10.9″ iPad Air- Place in location 2
• 10.9″ iPad (10th Gen) – Place in location 2
• 10.5″ i Pad Pro – Place In location 2
• 10.2″ iPad (9th Gen)- Place in location l
  
  If REPEL is installed on 10.2″ iPad don’t use spacers.

Route cabling through access holes in the back plate.

1. PLACE TABLET INTO FACE PLATE
   Ensure that PREASSEMBLY steps have been followed concerning the rubber spacers.
   
2. PLACE BACKPLATE OVER THE FACEPLATE AND INSERT SCREWS
   Refer to base mounting instructions before proceeding with this step if you are using a VESA mounted base.
   

REFER TO CREDIT CARD BRACKET INSTRUCTIONS
TO FINISH YOUR SOLUTIONS ASSEMBLY (OPTIONAL)

Documents / Resources

VAULT AI-PRO-IP Mounting Component For Tablet [pdf] Instruction Manual AI-PRO-IP Mounting Component For Tablet, AI-PRO-IP, Mounting Component For Tablet, Component For Tablet, Tablet

References

• User Manual