Spark and Bell Solas Table Lamp
Specifications
- Product Codes: 604, 605, 606, 607, 700
- IP20 Rated
Product Information
The table lamps come in various product codes and are rated IP20 for indoor use. They feature different designs such as Opal Globe Shades and Rian Lamp.
Product Usage Instructions
User Instructions
- Unpack your table lamp and shade:
- Lamps with Opal Globe Shades: After inserting an appropriate bulb, fit the glass shade by screwing it onto the lamp base. Avoid over tightening to facilitate bulb replacement and ensure longevity.
- Rian Lamp: Place the shade into the groove in the lamp base fully. Insert an appropriate bulb.
- Plug your lamp into a socket and switch it on.
- Operate the inline switch to turn the lamp on and off.
Care Instructions
For care instructions, please contact us at Spark & Bell using the information provided below.
Contact Us
Email: contact@sparkandbell.com
Phone: 01273 230566
Address: Spark & Bell, Ground Floor, Victoria House, Vale Road, Portslade, BN41 1GG
FAQ
Q: Can I use LED bulbs with these table lamps?
A: Yes, you can use LED bulbs with these table lamps as long as they are compatible with the lamp’s socket.
Q: Are replacement shades available for purchase?
A: Yes, replacement shades are available for purchase. Please contact us for more information on ordering.
Product Codes: 604, 605, 606, 607, 700
IMPORTANT
Please read the following instructions and warnings before using your new lamp. Retain for future reference.
WARNING
- Ensure lamp is fully assembled before connecting to power.
- Do not exceed bulb wattage on the label.
- Only use bulb type as specified on the label.
- For indoor use only.
- Not suitable for use in a bathroom.
Included
- Table lamp with inline switch and plug
- Shade
Required:
- No special equipment
USER INSTRUCTIONS
- Unpack your table lamp and shade, and install shade:
Lamps with Opal Globe Shades: After inserting appropriate bulb, fit the glass shade by screwing onto the lamp base. To ensure easy replacement of bulbs and the longevity of your light, please avoid over tightening.
“Rian” Lamp: Place shade into groove in lamp base fully. Insert appropriate bulb. - Plug your lamp into a socket and switch on.
- Operate the inline switch to turn on and off.
CARE INSTRUCTIONS
- Switch off, unplug from the wall and allow to cool before replacing the bulb.
- Clean using a soft dry cloth only.
- If the lamp will not turn on, please replace the bulb, and/or check and replace the fuse in the plug in the first instance. Please contact us in the event this does not solve the issue.
Contact Us
01273 230566
@sparkandbell
Spark & Bell, Ground Floor, Victoria House, Vale Road, Portslade, BN41 1GG
Documents / Resources
 |
Spark and Bell Solas Table Lamp [pdf] Instruction Manual 604, 605, 606, 607, 700, Solas Table Lamp, Solas, Table Lamp, Lamp |
