PYLE PDWM2135 VHF Fixed Frequency Wireless Microphone System User Guide
PYLE PDWM2135 VHF Fixed Frequency Wireless Microphone System

*Each Wireless Microphone System operates within the qualied wireless operating frequency range listed as: 174-216MHz.*

This microphone system operates on high-eciency, low-consumption discharging techniques. Performance features include independent developed mobile frequency compression,expander circuitry, image frequency limiting circuits, multiple-checked silent and noise-free circuits, antenna diversity receiving circuit & switch impact noise defeat circuits.

The PDWM2135 – PDWM2140PDWM2145 were manufactured to be easy to use and still give you professional performance quality.

Simple Installation and Operation: 

  • Please note- select models come equipped with dierent transmitters and microphones.
  • Unscrew the bottom of the microphone (or slide open the battery compartment tray of the belt-pack transmitter) to install two ‘AA’ Batteries. Screw the Battery cap back on.
  • Plug your receiving unit into your mixer or amplier with a 1/4″ mono microphone cord.
  • Plug the receiving unit into your electrical wall outlet.
  • Turn the receiver ON by using the ON/OFF switch located at the front of the unit.
  • There is a switch located on each of the two microphones that turns each microphone ON/OFF & mutes them individually

FEATURES AND SPECIFICATIONS

PDWM2135 

System Features: 

  • VHF Narrow Band Receiver System
  • Dual Frequency Design (Channel A/B)
  • High Signal/Noise Ratio Performance
  • Broad Frequency Response Range & Low Distortion
  • Independent Adjustable Volume Control
  • Dual Independent Channel Antennas
  • RF Signal and AF Signal LED Indicators
  • Radio Frequency and Audio Frequency

Handheld Microphones: 

  • RF Power Output: >13dBm
  • Modulation Degree: >30KHz
  • Power Current: <110mA
  • Harmonic at Higher Degree: <60dB
  • Modulation Pattern: FM
  • Battery Powered, Require (2) x ‘AA’ Batteries -Each

System Receiver: 

  • Sensitivity: -95dBm (S/N:12dB)
  • RF Image Rejection:-75dB
  • Audio Dynamic Range: 95dB
  • T.H.D.: <1%
  • S/N Ratio: >70dB
  • Neighboring Channel / Interference: >70dB
  • Power: AC 120V, 60Hz
  • Receiver Dimensions (L x W x H): 8.07” x 5.75” x 1.64”

What’s in the Box: 

  • Receiver Base
  • (2) Handheld Microphones
    Instructions

Features

  • VHF Narrow Band Receiver System
  • Dual Frequency Design (Channel A/B)
  • High Signal/Noise Ratio Performance
  • Broad Frequency Response Range & Low Distortion
  • Independent Adjustable Volume Control
  • Dual Independent Channel Antennas
  • RF Signal and AF Signal LED Indicators
  • Radio Frequency and Audio Frequency

Transmitters

  • RF Power Output: >13dBm
  • Modulation Degree: >30KHz
  • Power Current: <110mA
  • Harmonic at Higher Degree: <60dB
  • Modulation Pattern: FM
  • Battery Powered, Require (2) x ‘AA’ Batteries -Each

System Receiver: 

  • Sensitivity: -95dBm (S/N:12dB)
  • RF Image Rejection:-75dB
  • Audio Dynamic Range: 95dB
  • T.H.D.: <1%
  • S/N Ratio: >70dB
  • Neighboring Channel / Interference: >70dB
  • Power: AC 120V, 60Hz
  • Receiver Dimensions (L x W x H): 8.07” x 5.75” x 1.64” -inches

What’s in the Box: 

  • Receiver Base
  • Handheld Microphone
  • Body-Pack Transmitter
  • Lavalier Microphone
  • Headset Microphone
  • 1/4” Audio Connection Cable
    Instructions

System Features: 

  • VHF Narrow Band Receiver System
  • Dual Frequency Design (Channel A/B)
  • High Signal/Noise Ratio Performance
  • Broad Frequency Response Range & Low Distortion
  • Independent Adjustable Volume Control
  • Dual Independent Channel Antennas
  • RF (Radio Frequency) Signal Indicator
  • AF (Audio Frequency) Signal Indicator

Belt-Pack Transmitters: 

  • Modulation Pattern: FM
  • RF Power Output: >13dBm
  • Modulation Degree: >30KHz
  • Power Current: <110mA
  • Harmonic at Higher Degree: <60dB
  • Battery Powered, Require (2) x ‘AA’ Batteries -Each

System Receiver: 

  • Sensitivity: -95dBm (S/N:12dB)
  • RF Image Rejection:-75dB
  • Audio Dynamic Range: 95dB
  • T.H.D.: <1%
  • S/N Ratio: >70dB
  • Neighboring Channel / Interference: >70dB
  • Power: AC 120V, 60Hz
  • Receiver Dimensions (L x W x H): 8.07” x 5.75” x 1.64”

What’s in the Box:

  • Microphone Receiver
  • (2) Body-Pack Transmitters
  • (2) Headset Microphones
  • (2) Lavalier Microphones
    Instructions

VISIT US ONLINE:
Have a question? Need service or repair?
Want to leave a comment? PyleUSA.com/ContactUs

Instructions

Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com

PYLE LOGO

Documents / Resources

PYLE PDWM2135 VHF Fixed Frequency Wireless Microphone System [pdf] User Guide
PDWM2135, PDWM2140, PDWM2145, PDWM2135 VHF Fixed Frequency Wireless Microphone System, PDWM2135, VHF Fixed Frequency Wireless Microphone System, Frequency Wireless Microphone System, Wireless Microphone System, Microphone System

References

Leave a comment

Your email address will not be published. Required fields are marked *