Piper SC Flaps Tuning

INSTALLATION INSTRUCTION

Specifications

• Product Name: Piper SC
• Material: Carbon Fiber
• Dimensions: 80mm x 80mm
• Thickness: 1.5mm

Product Usage Instructions

Preparation

1. Identify the components labeled as Vztlaky – Flaps.
2. Ensure you have the necessary tools for cutting and marking.

Assembly

1. Cut the provided Carbon fiber pieces according to the specified measurements.
2. Mark the designated areas on the flaps as indicated in the manual.

Installation

1. Position the surfaces of the levers flaps away from the fuselage, refer to picture 17 for guidance.
2. Secure the components using Medium CA adhesive as directed.
3. Ensure proper centering of the servo for optimal functionality.

FAQ (Frequently Asked Questions)

Q: What should I do if I encounter difficulty in cutting the carbon fiber pieces?
A: Make sure to use a sharp cutting tool and apply steady pressure to achieve clean cuts. You can also seek assistance from a professional if needed.

Q: Can I use a different adhesive than Medium CA for installation?
A: It is recommended to use Medium CA adhesive for secure bonding. Using a different adhesive may affect the product’s performance.

Documents / Resources

Piper SC Flaps Tuning [pdf] Installation Guide SC Flaps Tuning, SC, Flaps Tuning, Tuning

References

• User Manual