Novolin LS-101B-WLVCTL Smart Wireless Controller for Low-Voltage Landscape Transformers
Download the App
Controller Position
Inside the Connector
Setup
- Download the Novolink Lightscape™ App from Google Play (Android) or the App Store (iOS).
- Turn OFF power to the Low-Voltage Transformer at the circuit breaker or fuse. Test to ensure the power is OFF.
- Assemble the Controller.
- Locate the Controller’s Connector, and pull the tabs up to remove the caps.
- Choose a section of the low-voltage line between the transformer and the first light fixture, with enough slack in the line. Cut it here with wire-cutters.
- Take each end of the cut low-voltage line and lead it through its corresponding channel, marked either From the Transformer or marked To Lights, respectively. Snap the caps back in place.
- Plant the stake into the ground and settle the connector above or below the ground.
- Reconnect power to the transformer and turn it ON. IMPORTANT: Any timers or photo sensors must
be turned OFF, and the transformer must remain continuously ON. - Open the Novolink Lightscape™ App, and add the Controller. Assign it a zone.
Need more help? Visit: novolinkinc.com
Documents / Resources
 |
novolink LS-101B-WLVCTL Smart Wireless Controller for Low-Voltage Landscape Transformers [pdf] User Guide LS-101B-WLVCTL, Smart Wireless Controller for Low-Voltage Landscape Transformers, LS-101B-WLVCTL Smart Wireless Controller for Low-Voltage Landscape Transformers |
