myStrom WiFi Button Plus
Quick Start
Download the myStrom App
![]() |
![]() |
![]() |
![]() |
LaunchApp
Open a free account or connect with your existing one
Select «Add device» in the menu to add your new WiFi Button.
AII Done
The WiFi Button supports 3 programmable push-patterns.
Short Push (approx. 1/2 second)
Long Push (approx. 2 seconds)
2x sequential short pushes (within 2 seconds)
LED
Off | WiFi Button inactive/ no power |
White/ blinks every 15 seconds | WLAN connection Mode (WPS) for 2 minutes after Reset |
Blinks white/red | Manual WLAN Connection Mode |
Blinks 1 Ox white | Reset successful |
Blinks 3x greenX | WPS successful |
Blinks 3x red | WPS unsuccessful |
Connection Mode
WPS | During 2. minutes – if not connected to a WLAN network or after Reset |
Manual | Push button after 2 seconds during WPS Mode |
Reset
Push the button for 10 seconds> it will blink white/red> release
your finger> within 5 seconds, push it again, once> it will blink 10x white – this will Reset the WilFi Button to its factory settings. The connection to your WLAN network is lost.
Battery in this device: WG 602530 / 3.7V / 400mAh / Li-Po
The battery and the device must be disposed of separately. To do this, open the device by pressing both halves apart and disconnect the battery from the electronics.
FAQ & Support
Recharge the built-in battery
Charge with the USB cable.
The WiFi Button is not working?
Place the WiFi Button close to your Router
Re-connect the WiFi Button
Reset it – the Button is now in WPS Mode for 2 minutes. Push the WPS button on your router. If the Button blinks 3x in green, it has reconnected. If it blinks 3x in red – please repeat the Reset procedure.
Further help & contact form mystrom.com/support
Documents / Resources
![]() |
myStrom WiFi Button Plus [pdf] Instruction Manual WiFi Button Plus, Plus, Button, WiFi |