MethaLock DAGfp2rLJJM Semi Automated Capping Machine
Product Information
Specifications
- Screwdriver (Drill): 120VAC, 0.96-4.90 NM/1000RPM
- Bench Clamp: For DR90-30001 Tool Stand
- Balancer: 39 Travel, 1.1-3.3 lb Range
- Chuck: C134 Chuck with inserted L134A white rubber liner for use with 38-46mm OD Caps
- Rubber Liner: C134 L134A white rubber liner, 55 durometer, for use with 38-46mm OD caps
Product Usage Instructions
Step 1: Setup
Place the capping machine on a stable surface and ensure all components are securely attached.
Step 2: Adjustments
Adjust the bench clamp to fit the specific tool stand and ensure proper alignment.
Step 3: Chuck and Liner Setup
Insert the Chuck with the white rubber liner for the desired cap size within the recommended range.
Step 4: Power On
Connect the screwdriver to a power source and turn it on to the specified RPM for capping.
Step 5: Capping Process
Place the cap on the container and position it under the screwdriver to initiate the capping process.
Capping Work Station
Batch filling methadone prescriptions can be time-consuming, tedious, and physically demanding. MethaLock’s semi-automated capping workstation provides a solution when large fill loads require speed and ensure worker safety .
Say Goodbye to wrist pain & hello to smooth Operation
FAQs
Q: Can this capping machine handle caps of various sizes?
The machine is designed to work with caps ranging from 38mm to 46mm in outer diameter.
Q: Is the capping process fully automated?
While it is semi-automated, manual intervention is required to place the cap before initiating the capping process.
Documents / Resources
 |
MethaLock DAGfp2rLJJM Semi Automated Capping Machine [pdf] Instruction Manual DAGfp2rLJJM, DAGfp2rLJJM Semi Automated Capping Machine, Semi Automated Capping Machine, Automated Capping Machine, Capping Machine, Machine |