KOLINK Observatory Y ARGB Midi Tower Case User Manual
Contents
hide
ACCESSORY PACK CONTENTS
PANEL REMOVAL
- Left Panel – Pull the tab to open the hinged glass panel and lift off the hinges
- Right Panel – Unscrew the two thumbscrews and slide off.
- Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release.
MOTHERBOARD INSTALLATION
- Align your motherboard with the chassis to locate where the stand-offs should be installed.
Once done, remove the motherboard and fasten stand-offs accordingly. - Insert your motherboard I/O plate into the cutout at the rear of the case.
- Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
- Use the provided motherboard screws to attach your motherboard to the chassis.
POWER SUPPLY INSTALLATION
- Place PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
- Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
- Graphics card can also be mounted vertically using the Vertical GPU bracket & riser cable kit (sold separately)
2.5″ SDD INSTALLATION (R)
- Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drive and then screw back into place.
2.5″ SDD INSTALLATION (R)
- Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
3.5″ HDD INSTALLATION
- Place the 3.5″ HDD into/on top of the HDD bracket and screw in if required.
TOP FAN INSTALLATION
- Remove the dust filter from the top of the case.
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
- Replace your dust filter once secured.
FRONT/REAR FAN INSTALLATION
- Align your fan to the screw holes on the chassis and secure with screws.
WATERCOOLING RADIATOR INSTALLATION
- Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
I/O PANEL INSTALLATION
- Carefully check the labelling of each connector from the I/O panel to identify their function.
- Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.
Documents / Resources
![]() |
KOLINK Observatory Y ARGB Midi Tower Case [pdf] User Manual Observatory Y ARGB Midi Tower Case, ARGB Midi Tower Case, Midi Tower Case, Tower Case, Observatory Y |