Go Power GP-SB-PWM-30-BT 30 Amp Single Bank Bluetooth Enabled Solar Controller
FAQs
Q: What should I do if I encounter a reverse polarity issue?
A: If you encounter a reverse polarity issue, immediately disconnect the battery/solar connections and rectify the wiring before reconnecting.
Q: Can I extend the wire length beyond 25ft from the solar panels?
A: It is not recommended to extend the wire length beyond 25ft as it may affect the performance and efficiency of the system.
SPECIFICATIONS
| SPECIFICATIONS | |
|
Nominal System Voltage |
12V |
| Nominal Charge Current | 30A |
| Battery Voltage Range | 6V — 16Vdc |
| Max Battery Charge Current | 37.5A |
| Max Solar Power | 600W |
| Display Consumption | 15mA |
| Temp. Compensation | – 25mV/ºC |
| Operating Temperature | – 40 to 60°C / – 40 to 140°F |
| Humidity | 99% N.C. |
| Dimensions (H x W x D): | 4.02 x 5.2 x 1.26 in; 102 x 132 x 32 mm |
| Weight | 260 g / 9.2 oz |
| Maximum Wire Gauge: | #8 AWG/10 mm2 |
| Warranty | 5 years |
|
Protection |
Battery/Solar Reverse Polarity, Battery/Solar Short Circuit, Battery/Solar Reverse Current, Battery/Solar Over voltage up to 50V, Over temperature, Over Current |
WARNINGS:
OVERVIEW
| NO. | DESCRIPTION | NO. DESCRIPTION | |
| 1 | Scroll/Menu Selectors | 4 | Value Indicators |
| 2 | Icons Indicator | 5 | Value Units |
| 3 | Parameters Identifiers | 6 | Battery Type Indicator |
TOOLS
- Flathead Screwdriver (for wire terminals)
- Philips Screwdriver (for mounting screws)
INSTALLATION
INSTALLATION STEPS:
Install your solar array, and cover with opaque material until all wiring is complete. Wiring should not exceed 25ft from the solar panels to the battery. Wire the GP-SB-PWM-30BT according to the wiring diagram below. Be sure to torque all screws based on the wire gauge after installation, as well as after 30 days.
The GP-SB-PWM-30BT is designed to be mounted flush against a wall, out of the way but easily visible.
The GP-SB-PWM-30BT should be:
- Mounted as close to the battery bank as possible
- Mounted on a vertical surface to optimize cooling of the unit
- Indoors, protected from the weather
ACCESSING SETTINGS
The GP-SB-PWM-30BT includes an LCD of FSTN type with 4 mechanical buttons that act as navigation keys to control the display. The GP-SB-PWM-30BT settings can be accessed by entering menu number 2 as shown below.
VIEWING CONTROLLER DISPLAY
Three menus are implemented in the display: status, settings, and history. At power-up, the controller turns on within the status menu. The different menus can then be accessed by pressing the Enter key as shown below.
BLUETOOTH FEATURE
A Bluetooth® Low Energy module is integrated into the 30A model only. For details on the data that can be accessible/managed via Bluetooth®, please refer to the GP-SB-PWM-10/30BT User Manual.
MORE INFO
Scan for full manual
Documents / Resources
 |
Go Power GP-SB-PWM-30-BT 30 Amp Single Bank Bluetooth Enabled Solar Controller [pdf] User Guide GP-SB-PWM-30-BT 30 Amp Single Bank Bluetooth Enabled Solar Controller, GP-SB-PWM-30-BT, 30 Amp Single Bank Bluetooth Enabled Solar Controller, Bank Bluetooth Enabled Solar Controller, Bluetooth Enabled Solar Controller, Enabled Solar Controller, Controller |