Firelex IBS-P01R Wireless Pool Thermometer and Receiver Set Instruction Manual

IBS-P01R Wireless Pool Thermometer and Receiver Set

Specifications

  • Model: Pool Thermometer PT-200
  • Measurement Range: -10°C to 50°C
  • Accuracy: ±1°C
  • Transmission Distance: Up to 30 meters
  • Power Source: 2 AAA batteries (transmitter), 2 AA batteries
    (receiver)

Product Usage Instructions

Introduction

This Pool Thermometer PT-200 is designed to accurately measure
the temperature of pools and provide reliable readings for your
convenience.

Basic Operation

Insert batteries into both the transmitter and receiver units.
Ensure both are powered on and properly synced for accurate
temperature readings.

Troubleshooting Guide

If you encounter any issues with the pool thermometer, refer to
the following troubleshooting steps:

Water/Condensation Inside the Transmitter

  • Causes: Large temperature difference, wet
    hands during battery installation, loose transmitter cover.
  • Solutions: Adjust transmitter position, wipe
    off moisture, ensure tight cover. Contact customer service if issue
    persists.

Inaccurate Temperature Readings

  • Causes: Temperature difference, device
    placement, damaged probe.
  • Solutions: Check device integrity, place
    devices side by side for testing. Contact customer service if
    needed.

Transmitter Screen Not Showing

  • Causes: Dead battery, reversed direction,
    internal damage.
  • Solutions: Check device integrity, replace
    batteries correctly. Contact customer service if issue
    persists.

Rust Inside the Transmitter

  • Causes: Water vapor oxidation, battery
    leakage.
  • Solutions: Wipe off rust, dry transmitter
    indoors before installing new batteries. Ensure dry hands during
    battery installation. Contact customer service if needed.

Receiver Disconnects/Loses Connection

  • Causes: No pairing performed, distance too
    far, low battery power.
  • Solutions: Perform pairing, keep devices close
    for connection, replace batteries if necessary.

Frequently Asked Questions (FAQ)

Q: How do I pair the transmitter and receiver?

A: Hold the pool thermometer (transmitter) close to the receiver
and press the Tx button on the transmitter to establish a
connection.

Q: What should I do if the temperature readings are
inaccurate?

A: Check device placement and integrity. Place the transmitter
and receiver side by side indoors for testing. Contact customer
service if the issue persists.

Q: How can I prevent rust inside the transmitter?

A: Wipe off any rust, dry the transmitter indoors before
installing new batteries, and ensure dry hands during battery
installation.

Q: The transmitter screen is not displaying. What could be the
issue?

A: Check the battery status, correct orientation, and for any
internal damage. Replace batteries if needed and contact customer
service if the problem continues.

“`

Please keep this manual properly for reference. You can also scan the QR code below to visit our official web site for product usage videos. For any usage issues, please
feel free to contact us at support@inkbird.com. Wenn Sie eine Bedienungsanleitung in deutscher Sprache benötigen, scannen Sie bitte den QR-Code und besuchen Sie unsere Website, um sie zu erhalten und ein Video über die Verwendung des Produkts zu sehen.

Se avete bisogno di un manuale di istruzioni in italiano, scansionate il codice QR e visitate il nostro sito web per
ottenerlo e vedere un video su come utilizzare il prodotto.
Si vous avez besoin d’un mode d’emploi en français, veuillez scanner le code QR pour visiter notre site
officiel afin d’obtenir et de visionner la vidéo d’utilisation du produit !
Als je een Nederlandstalige handleiding nodig hebt, scan dan de QR-code om naar onze officiële website te gaan
en bekijk de video over het gebruik van het product! Si necesita el manual de instrucciones en español, escanee el código QR para ir a nuestro sitio web oficial y
ver el vídeo sobre cómo utilizar el producto.

Warm tips
To quickly jump to a specific chapter page, click on the relevant text on the contents page.
You can also use the thumbnail or document outline in the top left corner to quickly find a specific page.

Introduction

1

Parameters

2

Basic Operation

4

FCC Requirement

11

05 Troubleshooting Guide

13

4. FCC Requirement

5.Troubleshooting Guide

Issues Causes

Solutions

Water/condensation inside the transmitter

1. Large temperature difference in the environment. 2. Hands were not kept dry when installing the batteries. 3. The cover of the transmitter is not tightened.

1. Adjust the position of the transmitter. 2. Wipe off the internal moisture. Remove the batteries and place it in a dry environment to dry before installing new batteries. 3. Make sure the lid is tight. If it still doesn’t work, please contact customer service.

13

Issues Causes

Solutions

Inaccurate temperature readings

1. There is a

1. Check if the device is

temperature

intact.

difference in the 2. Place the transmitter and

position where the receiver side by side

device is placed. indoors for testing.

2. Deviation within If the readings are still far

the temperature off, please contact

accuracy range. customer service.

3. The probe is

damaged.

Transmitter screen not showing

1. The battery is dead or the direction is reversed. 2. Internal damage.

1. Check if the device is intact. 2. Replace new batteries and check the batteries orientation. If it still doesn’t work, please contact customer service.

There is rust inside the transmitter

1. Water vapor oxidation. 2. Battery leakage.

1. Please wipe off the rust. Place the transmitter indoors to dry before installing new batteries. 2. When installing batteries, make sure your hands are dry. If it still doesn’t work, please contact customer service.

14

Issues Causes

Solutions

Receiver disconnects/los-

No pairing was performed

Hold the pool Thermomter (Transmitter) close to the Receiver and

es

press the Tx button on the

connection to pool

The distance is too pool Themmomefar to disconnect ter(Transmitter)

thermom-

e-

The pool

ter(Trans- thermometer

mitter) (Transmitter)

has run out of

Reinstall the batteries

power.

15

Factory Address: Room 501, Building 138, No. 71, Yiqing Road, Xianhu Community, Liantang Street, Luohu District, Shenzhen, China

Documents / Resources

Firelex IBS-P01R Wireless Pool Thermometer and Receiver Set [pdf] Instruction Manual
IBS-P01R, 103.01.00499, IBS-P01R Wireless Pool Thermometer and Receiver Set, Wireless Pool Thermometer and Receiver Set, Pool Thermometer and Receiver Set, Thermometer and Receiver Set, Receiver Set

References

Leave a comment

Your email address will not be published. Required fields are marked *