DPX Power Source
Enclosure System
DPX Power Source Enclosure System
- Compact footprint ideal for ground mount installations in Right-of-Way for small cell applications
- Provides power for up to 10 small cell nodes from a single grid tap connection
- Wide AC input voltage range (90 to 305 Vac) for worldwide deployment
- Type 3R rated outdoor cabinet with heat exchanger for improved energy efficiency and reduced maintenance costs
- Optional energy storage enclosure available
The DPX Power Source enclosure system is part of the distributed power transport product family specifically engineered using the new Alliance for Telecommunications Industry Solutions (ATIS) fault managed power distribution technology.
The DPX Power Source enclosure system is housed in a Type 3R rated enclosure and designed for pole and ground mount installations. The enclosure system can remotely power up to 10 small cell nodes from a single grid tap connection. Optional energy storage cabinet is available to support additional backup time.
Local and remote setup, adjustment and control is a simple single-step process with the system controller. By utilizing TCP/IP technology, complete configuration and monitoring of power equipment is possible through a network web browser or via local isplay.
Distributed power transport architecture enables operators to deploy their network faster by eliminating the need to have AC utility power at each small cell location. At a central location, the central power hub converts the incoming AC power to fault managed power which is transported over a hybrid or copper only cable to a disconnect box and then to a down converter device located approximately 6000 ft away. This reduces installation and operating expenses, and provides flexibility related to site selection for the installation of the remote communications equipment
DPX Power Source Enclosure System
Consult your Alpha® sales representative for system configurations.
| Electrical | |
| Input Voltage | Nominal: 208 to 277 Vac |
| Operating: 187 to 305 Vac | |
| Extended: 90 to 187 Vac (derated power) | |
| Input Frequency | 45.0 Hz to 66.0 Hz |
| Power Factor | >95% (10 to 100% load) |
| THD | <5% (50 to 100% load) |
| Output Voltage | ±190 Vdc |
| Output Power | 10 × 2000 W channels |
| Acoustic | <65 dbA |
| Features | |
| Protection | •Pad-lockable door handles •1 x 20kA AC surge suppression •10 x 20kA DC surge suppression |
| Energy Storage Support Options | • AlphaCap 665 for short duration backup of Cordex® CXC HP controller • PowerSafe® SBS 190F batteries installed inside PSE for backup, up to 5 channel outputs •Energy storage enclosure for extended backup |
| Mechanical | |
| Dimensions H × W × D | Overall: 1232 × 1016 × 889 mm (48 × 40 × 35 in.) |
| Footprint: 1232 × 1016 × 610 mm (48 × 40 × 24 in.) | |
| Weight | 180 kg (397 lb) |
| Mounting | •Ground •Pole (no battery application) |
| Cooling | 130 W/◦C (72 W/◦F) Heat Exchanger |
| Environmental | |
| Temperature | Operating: –40 to 46°C (–40 to 115°F); plus solar loading |
| Storage: –40 to 85°C (–40 to 185°F) | |
| Relative Humidity | 5 to 95% non-condensing |
| Elevation | Up to 3,000 m (9,842 ft) |
| Cabinet Rating | Type 3R |
| Agency Compliance | |
| Safety | •CSA-US Field Evaluation •ATIS (Pending) •CSA/UL 62368-1 (Pending) |
© 2023 EnerSys. All rights reserved. Trademarks and logos are the property of EnerSys and its affiliates unless otherwise noted. Subject to revisions without prior notice. E.&O.E
| EnerSys World Headquarters 2366 Bernville Road, Reading, PA 19605, USA Tel: +1-610-208-1991 +1-800-538-3627 |
EnerSys EMEA EH Europe GmbH, Baarerstrasse 18, 6300 Zug Switzerland |
EnerSys Asia 152 Beach Road, Gateway East Building #11-08, Singapore 189721 Tel: +65 6416 4800 |
09/2023
#0480092-00 REV A
Documents / Resources
 |
alpho DPX Power Source Enclosure System [pdf] Owner's Manual DPX Power Source Enclosure System, DPX, Power Source Enclosure System, Source Enclosure System, Enclosure System |