KSIPZE 2A427-LEDSTRIP LED Strip Lights USB Magic Color Controller Smart Bluetooth APP
Specifications
- Compliance: Part 15 of FCC Rules
- Operating Conditions: Avoid harmful interference
- Distance Requirement: Minimum 20cm between radiator and body
- Installation: Antenna(s) should not be co-located with other transmitters
About Settings
- In the setting interface, you can set the IC model, color correction, number of points(Total number of points can not exceed 300 in each segment and total LED chips quantity can not exceed 2048)
- The setting of IC number is applied to the smearing function
Detailed introduction of APP functions:
Multi color function
The color of the light can be adjusted by the whole and each segment. App provides different columns for color selection or editing, and the brightness can also be adjusted. In the segmentation interface, users can freely smear or erase the color of each segment, and also set the gradient effect. 
Scene settings
There are Four Build-in scenes:” Life”, “Scenery”, “Festivals”, “Mood”, and click “D IY” or “Co I lectio n” to create your favorite light effect.
Playlist mode
Multiple light dynamic modes built in, can set the time of lighting effects and enter cycle mode .Select different scene modes, then set the du ration of each scene respectively, and play it by combining the sequence of different lighting effects.
Smear function
Click “+”to DIV the lighting color and dynamic effects then save it.
Before DIV, please set the number of IC in “Settings” to ensure that the number of lights is consistent with the device, Otherwise, the lighting effect is incorrect. Before customize, please ensure that the IC number in app setting is the same as the light device, otherwise, the lighting effect will be incorrect.
Rhythm Mode
Built-in Three rhythm modes: Music mode, phone mic, and device mic (According to the device configuration).
LED light will change tight effect with the volume/noise from the outside as a Microphone. This also works when playing music or there is a noise from outside, the light color wi II sync with rhythm. The microphone sensitivity can be adjusted.
Light timer
LED lights can automatically turn on or off at a specific time as the schedule .
Group Control
This mode allows you to create different groups to control more than one controllers at the same time.
Attentions
Please use the product in a dry environment. b) For input voltage, please use the DC voltage within the specified range as instructed in the manual, must not connect into 220V AC directly.c) The product is requested common anode connection. The wrong connection will cause a malfunction.
WARNING
- Please do not put the string lights in contact with heat sources or flames.
- Children under the age of 16 should use this product under adult supervision.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Statement
To maintain compliance with FCC’S RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm between the radiator and your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
FAQ
- Q: What should I do if I encounter interference while using the device?
A: If you experience interference, try adjusting the positioning of the device or relocating it to minimize interference. Ensure other electronic devices are not causing the interference. - Q: Can I modify the device for better performance?
A: No, any modifications not expressly approved may impact the compliance and void your authority to operate the equipment as per FCC regulations.
Documents / Resources
 |
KSIPZE 2A427-LEDSTRIP LED Strip Lights USB Magic Color Controller Smart Bluetooth APP [pdf] User Manual 2A427-LEDSTRIP LED Strip Lights USB Magic Color Controller Smart Bluetooth APP, 2A427-LEDSTRIP, LED Strip Lights USB Magic Color Controller Smart Bluetooth APP, Lights USB Magic Color Controller Smart Bluetooth APP, Magic Color Controller Smart Bluetooth APP, Controller Smart Bluetooth APP, Smart Bluetooth APP, Bluetooth APP |