1. 서론
This manual provides detailed instructions for the installation, operation, and maintenance of your Cenmate 5-Bay Hybrid Hard Drive Enclosure. This enclosure is designed to expand your storage capacity by combining 2.5/3.5 inch SATA HDDs/SSDs and M.2 NVMe SSDs, offering versatile storage solutions with high-speed data transfer.
Image 1.1: Cenmate 5-Bay Hybrid Enclosure
2. 제품 특징
- Hybrid Storage Design: Supports 2 x 2.5/3.5 inch SATA HDDs/SSDs and 3 x M.2 NVMe SSDs (2230/42/60/80/110).
- 대용량: Maximum total capacity of 68TB (2x22TB HDDs + 3x8TB M.2 SSDs).
- RAID 모드: Supports RAID 0, RAID 1, JBOD, and Normal modes for SATA drives. 메모: RAID configuration may result in data loss. Always back up data before configuring RAID.
- 고속 연결: USB 3.2 Gen 2 interface provides data transfer rates up to 10Gbps.
- 효율적인 냉각: Built-in aluminum alloy housing and a 2.7-inch silent fan ensure optimal heat dissipation.
- 도구 없이 설치: Features a tool-free hard drive tray design for easy installation and removal of 3.5-inch SATA drives.
- 폭넓은 호환성: Compatible with Windows 7 and above, Mac OS 9.1 and above, and Linux. USB Type-C interface supports USB 3.0, USB 3.1, USB 3.2, Thunderbolt 3, and Thunderbolt 4.
이미지 2.1: 제품 특징 요약view
3. 패키지 내용
패키지에 모든 품목이 들어 있는지 확인하세요.
- Cenmate Hybrid Hard Drive RAID Enclosure
- USB A/C 3.2 Cable
- 전원 어댑터
- 사용 설명서 (본 문서)
4. 설정 및 설치
4.1 M.2 SSD 설치
- Insert the M.2 SSD into the slot until it clicks into place.
- 고무 플러그를 M.2 SSD의 금속 반원에 끼웁니다.
- Press the rubber plug with the M.2 SSD down into the bayonet until it is secure.
Image 4.1: M.2 SSD Installation Steps
4.2 3.5 inch HDD Installation
- Pull up the blue clasps on both sides of the bracket.
- Put the hard drive gently into the tray, then snap the carabiner pins into the 3.5 inch HDD side screw holes.
Image 4.2: 3.5 inch HDD Installation Steps
4.3 2.5 inch HDD/SSD Installation
- 드라이버를 사용하여 측면의 파란색 걸쇠를 제거하세요.
- Use screws to secure the 2.5 inch HDD/SSD in the corresponding holes on the tray.
Image 4.3: 2.5 inch HDD/SSD Installation Steps
5. RAID 구성
The Cenmate enclosure supports four RAID modes for SATA drives: Normal, RAID 1, RAID 0, and JBOD. M.2 NVMe SSDs are always treated as independent drives.
Important Note: Press and hold the "Reset" button for 5 seconds after resetting the RAID array. Designing or changing RAID modes may result in data loss. Always back up your data before performing RAID configuration.
Image 5.1: RAID Mode Configuration
- 정상: Each drive operates independently. (Switch 1 & 2 are down)
- RAID 1(미러링): Data is duplicated across two drives for redundancy. Requires two drives. Capacity equals the smallest drive. (Switch 1 & 2 are up)
- RAID 0 (스트라이핑): Data is split across two drives for increased speed. Requires two drives. Total capacity is the sum of both drives. (Switch 1 up & Switch 2 down)
- JBOD(Just a Bunch Of Disks): Drives are concatenated to form a single large volume. Requires two drives. Total capacity is the sum of both drives. (Switch 1 down & Switch 2 up)
6. 사용 설명서
After installing your drives and configuring RAID (if desired), connect the enclosure to your computer using the provided USB A/C 3.2 Gen 2 cable and power adapter. Power on the device using the switch on the rear panel. Your operating system should detect the drives. For new drives, you may need to initialize and format them through Disk Management (Windows) or Disk Utility (macOS) before use.
6.1 데이터 전송
The enclosure supports up to 10Gbps data transfer speeds. Actual speeds may vary based on your drives, computer's USB port, and operating system.
비디오 6.1: 끝view of the Cenmate Hybrid Storage Enclosure and its features.
7. LED 표시기
The enclosure features LED indicators for each drive bay to provide status information:
Image 7.1: LED Indicator Guide
- M.2-1 (Purple LED): Always blue when connected, flashes when reading/writing.
- M.2-2 (Red LED): Always red when connected, flashes when reading/writing.
- M.2-3 (Red LED): Always red when connected, flashes when reading/writing.
- HDD1 (Blue LED): Always blue when connected. If incompatibility or damage occurs, the blue light will show red. Flashes red when reading/writing.
- HDD2 (Blue LED): Always blue when connected. If incompatibility or damage occurs, the blue light will show red. Flashes red when reading/writing.
8. 호환성
The Cenmate 5-Bay Hybrid Enclosure offers broad compatibility with various operating systems and devices.
8.1 Supported M.2 NVMe SSDs
The enclosure supports M.2 NVMe SSDs with M Key and M&B Key (NVMe/PCIe) in sizes 2230, 2242, 2260, 2280, and 22110.
Image 8.1: M.2 NVMe SSD Compatibility
8.2 Supported Operating Systems and Devices
The enclosure is compatible with:
- 운영 체제: Windows 7 and above, macOS 9.1 and above, Linux, Chrome OS.
- 장치: Desktops, Laptops.
- USB 인터페이스: USB 3.0, USB 3.1, USB 3.2, Thunderbolt 3, Thunderbolt 4.
Image 8.2: System and Device Compatibility
9. 문제 해결
다음은 흔히 발생하는 문제와 그 해결책입니다.
9.1 Hard Drive Not Found / RAW Format
Image 9.1: Troubleshooting Q1 & Q2
- Q1: After connecting a new hard drive, why can't I find it or see its disc letter?
A1: New hard drives must be formatted before use. Right-click 'Computer' (or 'This PC'), then 'Manage', open 'Disk Management'. Find the new hard drive, right-click 'Initialize Disk' (select 'MBR' for drives ≤ 2TB, 'GPT' for drives > 2TB). Then, 'New Simple Volume' and follow the prompts to format the partition. - 질문 2: 디스크 관리에서 하드 드라이브가 RAW 형식으로 표시되는데, 이는 잘못된 추출 또는 정전으로 인해 발생합니다. 어떻게 해야 하나요?
A2: You can attempt recovery using thechkdskcommand. Run Command Prompt as administrator, then inputchkdsk D:/f(replace 'D' with the actual drive letter). Scanning and repair will complete, and a reboot may be required.
9.2 기타 일반적인 문제
Image 9.2: Troubleshooting Q3-Q5
- Q3: The hard drive is dynamically invalid in Disk Management because it was previously removed from an old computer.
A3: This is a system-related issue. Reinstall the hard drive into the original computer motherboard and back up the data. If the old computer is unavailable, you can use dynamic disk conversion software to convert it to a basic disk. - Q4: Hard drive shows up but has no disc letter.
A4: In Disk Management, right-click on the Disk Partition section and select 'Change Drive Letter and Paths' to add a drive letter for use. - Q5: The enclosure automatically disconnects during transmission and then reconnects after a while.
A5: This could indicate issues with the computer's USB interface, the USB cable, computer USB drivers, the hard drive itself, or the hard drive enclosure. Contact technical support for assistance in diagnosing the problem.
10. 사양
| 사양 | 세부 사항 |
|---|---|
| 상표 | cenmate |
| 모델 번호 | 5 만 |
| 품목 무게 | 2.49파운드(1.13킬로그램) |
| 제품 치수 | 7.95 x 5.2 x 4.41 인치 |
| 메모리 저장 용량 | 68 TB (Maximum) |
| 호환 장치 | 데스크탑, 노트북 |
| 하드 디스크 폼 팩터 | 2.5인치, 3.5인치 |
| 지원되는 최대 장치 수 | 5 (2 SATA, 3 M.2 NVMe) |
| 데이터 전송 속도 | 초당 10기가비트(USB 3.2 2세대) |
| 하드웨어 인터페이스 | USB 3.2 2세대 |
| 하드웨어 플랫폼 | 윈도우, 맥, 리눅스 |
| 재료 | 알류미늄 |
11. 보증 및 지원
Cenmate provides lifetime technical support for this product. If you have any questions or encounter issues, please do not hesitate to contact us. We aim to reply and resolve your problem within 24 hours.
