1. 서론
The Silvergear 2-in-1 Pulse Oximeter Model 2238 is a compact and convenient device designed for non-invasive spot-checking of arterial oxygen saturation (SpO2) and pulse rate (PRbpm). It is suitable for use by adults and children in home environments, medical facilities, and during sports activities.
Monitoring blood oxygen levels is crucial for individuals with respiratory conditions such as asthma and COPD, heart conditions, and athletes. A normal blood oxygen saturation typically ranges between 95-100%. Slight variations are normal, but consistent or prolonged low readings should be discussed with a healthcare professional. This device also measures your heart rate.
For athletes training at high altitudes, such as during skiing, mountaineering, or flying, measuring oxygen saturation can be beneficial. In high-altitude environments, it is normal for blood oxygen saturation to be lower than usual. During physical exertion, oxygen levels may decrease slightly. This handy and compact oximeter allows for easy measurement and monitoring.
앞쪽 view of the Silvergear Pulse Oximeter displaying SpO2 and PRbpm readings.
2. 안전 정보
- Consult your doctor before using this device for medical diagnosis or treatment.
- This device is intended for non-medical use and self-monitoring. It is not a substitute for professional medical advice.
- MRI 또는 CT 환경에서 산소 농도계를 사용하지 마십시오.
- Do not use the oximeter in situations requiring continuous monitoring.
- 장치를 어린이나 애완동물의 손이 닿지 않는 곳에 보관하십시오. 작은 부품은 질식 위험이 있을 수 있습니다.
- Avoid exposing the device to direct sunlight, extreme temperatures, or moisture.
- 기기를 직접 수리하거나 개조하지 마십시오. 도움이 필요하시면 고객 지원팀에 문의하십시오.
3. 설정
3.1 패키지 내용
- Silvergear 2-in-1 Pulse Oximeter
- 사용자 설명서
3.2 배터리 설치
- 장치 뒷면에서 배터리 덮개를 찾으세요.
- 덮개를 밀어서 수납공간을 엽니다.
- Insert two 1.5V AAA batteries (not included) according to the polarity indicators (+/-) inside the compartment.
- 배터리 칸 덮개를 딸깍 소리가 나며 제자리에 단단히 고정될 때까지 다시 끼웁니다.
옆 view of the Silvergear Pulse Oximeter, illustrating its compact design.
4. 사용 설명서
4.1 측정하기
- 기기에 새 배터리가 장착되어 있는지 확인하십시오.
- cl을 열어라amp of the oximeter by pressing the top and bottom parts together.
- Insert one of your fingers (preferably the index or middle finger) into the rubber opening of the oximeter, ensuring your fingertip is placed against the stop guide.
- cl을 풀어주세요amp, allowing it to gently close around your finger.
- Press the power button on the front of the device to turn it on.
- Keep your hand still and avoid movement during the measurement. The display will show your SpO2 and pulse rate readings within a few seconds.
- The device will automatically shut off after approximately 8 seconds of inactivity.
The Silvergear Pulse Oximeter opened, ready for finger insertion.
A hand demonstrating correct finger placement in the Silvergear Pulse Oximeter for measurement.
4.2 디스플레이 이해
The clear LED display shows the following information:
- %SpO2: Blood Oxygen Saturation level.
- PRbpm: 분당 맥박수.
- Plethysmogram: A waveform indicating the pulse strength.
- 배터리 표시기: 남은 배터리 수명을 표시합니다.
Close-up of the Silvergear Pulse Oximeter display with labels indicating Oxygen Saturation, Pulse Rate, Plethysmogram, and Power Button.
또 다른 view of the Silvergear Pulse Oximeter in use on a finger, showing the active display.
5. 관리 및 유지 보수
5.1 청소
- 산소포화도 측정기의 표면을 부드러운 천으로 닦으십시오.ampened with medical alcohol (70% ethanol or isopropanol).
- Do not immerse the device in water or any other cleaning solution.
- 재사용하기 전에 기기가 완전히 건조되었는지 확인하십시오.
5.2 보관
- 산소포화도 측정기는 직사광선과 극한 온도 변화를 피해 서늘하고 건조한 곳에 보관하십시오.
- 장기간 기기를 사용하지 않을 경우, 누출 및 손상을 방지하기 위해 배터리를 제거하세요.
6. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 전원 버튼을 눌러도 화면이 표시되지 않습니다. | 배터리가 소진되었거나 올바르게 설치되지 않았습니다. | 배터리를 교체하거나 극성을 확인하여 올바르게 다시 설치하십시오. |
| 부정확하거나 불안정한 측정값 | Finger not inserted properly; excessive movement; cold fingers; nail polish or artificial nails. | Re-insert finger correctly; remain still; warm hands; remove nail polish/artificial nails. |
| "Finger Out" or similar error message | 손가락이 감지되지 않았거나 잘못된 위치에 있습니다. | Ensure finger is fully inserted and resting flat on the sensor. |
7. 기술 사양
- Oxygen Saturation Measurement Range: 70-99%
- 산소 포화도 정확도: ± 2% (70-99%), unspecified below 70%
- 맥박수 측정 범위: 30-240 박자
- 맥박수 정확도 : ± 2 bpm or ± 2% (whichever is greater)
- 표시하다: 주도의
- 전원 공급 장치: 2 x 1.5V AAA 배터리(포함되지 않음)
- 운영 볼륨tage: 2.6 - 3.6V
- 작동 전류: ≤ 30mA
- 자동 차단 : 약 8초간의 무활동
- 모델 번호: 2238
- 제조업체: Karsten International
8. 보증 및 지원
For warranty information or technical support, please refer to the documentation provided with your purchase or contact Silvergear customer service. Keep your proof of purchase for any warranty claims.
You can also visit the official Silvergear store for more information: Silvergear Store
9. 폐기
This product contains electronic components and batteries. Do not dispose of it with general household waste. Please follow local regulations for the disposal of electronic waste and batteries to protect the environment.
