장인 180552

Craftsman 180552 14-inch Walk-Behind Mower Replacement Wheels User Manual

소개

This manual provides essential instructions for the safe and correct installation and maintenance of your Craftsman 180552 replacement wheels. These wheels are designed for 14-inch walk-behind lawn mowers from brands such as Poulan, Husqvarna, and AYP, replacing part number 151138. Please read this manual thoroughly before proceeding with installation.

안전 정보

패키지 내용

패키지에 모든 품목이 들어 있는지 확인하세요.

설정 및 설치

This section guides you through the process of replacing the wheels on your walk-behind lawn mower.

필요한 도구:

설치 단계:

  1. 잔디 깎는 기계 준비: Ensure the lawn mower is turned off, the spark plug wire is disconnected, and the engine is cool. Tilt the mower onto its side (with the carburetor facing up to prevent fuel leakage) or use a sturdy jack to elevate the side where the wheel will be replaced.
  2. 기존 바퀴를 제거하세요:
    • Locate the center cap or nut cover on the old wheel. Carefully pry it off with a flathead screwdriver if present.
    • Using the appropriate wrench or socket, loosen and remove the nut or bolt securing the wheel to the axle.
    • Slide the old wheel off the axle. Note the position of any washers or spacers for reinstallation.
  3. 새 휠을 설치하세요:
    Two Craftsman 180552 14-inch replacement wheels for walk-behind lawn mowers, shown from the side with tread visible.

    Image: Two Craftsman 180552 14-inch replacement wheels. These wheels are designed for durability and proper fit on compatible lawn mowers.

    • Align the new Craftsman 180552 wheel with the axle. Ensure any washers or spacers are correctly positioned as they were with the old wheel.
    • 새 바퀴를 차축에 끼우세요.
    • Secure the wheel with the original nut or bolt. Tighten it firmly with the wrench or socket. Do not overtighten, as this can damage the wheel or axle.
    • If applicable, replace the center cap or nut cover.
  4. 설치 테스트: Gently spin the newly installed wheel to ensure it rotates freely without binding. Lower the mower and check for stability.

운영

Once the new wheels are installed, ensure they are functioning correctly before operating the lawn mower. The wheels should roll smoothly and provide adequate traction. If you notice any wobbling, binding, or unusual noises, re-check the installation steps and ensure all fasteners are securely tightened.

유지

문제 해결

문제가능한 원인해결책
바퀴가 흔들리거나 헐거워졌습니다.Nut/bolt not tightened sufficiently; incorrect washer placement.Ensure the securing nut/bolt is tightened properly. Verify washers/spacers are correctly installed.
바퀴가 자유롭게 회전하지 않습니다Overtightened nut/bolt; debris caught in axle; incorrect installation.Loosen the nut/bolt slightly if overtightened. Clean any debris from the axle area. Re-check installation steps.
바퀴에서 이상한 소음이 납니다Debris in wheel hub; damaged wheel bearing (if applicable); loose components.Inspect for and remove any debris. If noise persists, consult a qualified service technician.

명세서

보증 및 지원

For warranty information or technical support, please refer to the original purchase documentation or contact the retailer where the product was purchased. Specific warranty terms may vary.

관련 문서 - 180552

사전view Craftsman 21인치 잔디 깎는 기계 사용 설명서
Craftsman 21인치 잔디깎이 기계 사용 설명서입니다. 247.39775, 247.37815, 247.37833, 247.37860 모델의 안전 지침, 조립, 작동, 유지보수 및 문제 해결 방법을 담고 있습니다. 안전 작동, 조정 및 관리에 대한 자세한 안내가 포함되어 있습니다.
사전view Craftsman 잔디 깎는 기계 보증 및 서비스 정보
Craftsman 브랜드 잔디 깎는 기계에 대한 공식 보증 및 서비스 보충 자료로, MTD LLC에서 제공하는 제품 사양, 모델 번호, 보증 범위, 제한 사항 및 연락처 정보가 자세히 설명되어 있습니다.
사전view CRAFTSMAN 6.0 HP 22" Rear Discharge Rotary Lawn Mower Owner's Manual (Model 917.377130)
Comprehensive owner's manual for the CRAFTSMAN 6.0 HP 22" Rear Discharge Rotary Lawn Mower (Model 917.377130). Includes safety guidelines, assembly, operation, maintenance, troubleshooting, and repair parts information.
사전view Craftsman 잔디 깎는 기계 보증 및 서비스 보충 자료
이 문서는 Craftsman 잔디 깎는 기계에 대한 포괄적인 보증 및 서비스 정보를 제공하며, 보증 범위, 제외 사항, 서비스 이용 방법 및 주요 제품 사양을 자세히 설명합니다. 또한 다양한 잔디 깎는 기계 유형에 대한 모델 번호와 설명이 포함되어 있습니다.
사전view Craftsman Mower 247.374300 부품 목록 및 엔진 구성 요소
Craftsman 잔디깎이 모델 247.374300의 종합 부품 목록입니다. 모델 09P602-0039-F1의 엔진 구성품에 대한 자세한 분석도 포함되어 있습니다. 모든 잔디깎이 및 엔진 부품의 부품 번호와 설명을 확인하세요.
사전view Craftsman 917.379202 로터리 잔디 깎는 기계 사용 설명서
최적의 성능과 수명을 위한 안전, 작동, 유지관리 및 문제 해결 방법을 자세히 설명하는 Craftsman 917.379202 회전식 잔디 깎는 기계의 포괄적인 사용 설명서입니다.