소개
This manual provides detailed instructions for the safe installation, operation, and maintenance of your Satco 90-192 Brass Finish Ribbed Canopy Kit. Please read all instructions carefully before beginning installation and retain this manual for future reference. This canopy kit is designed to cover electrical connections at the ceiling or wall outlet box for various lighting fixtures.
안전 정보
경고: 감전 위험. 설치 또는 수리 전에 퓨즈 박스 또는 회로 차단기에서 전원을 차단하십시오.
- 전기 작업을 하기 전에 항상 회로 차단기 또는 퓨즈 박스에서 주 전원을 차단하십시오.
- 설치 과정의 어떤 부분이든 확실하지 않은 경우 자격을 갖춘 전기 기술자에게 문의하세요.
- 모든 전기 연결이 안전한지 확인하고 해당 지역의 전기 규정을 준수하세요.
- Do not install this product in wet locations unless specifically rated for such use.
- 손상을 방지하기 위해 모든 구성품을 조심스럽게 다루십시오.
패키지 내용
설치를 시작하기 전에 모든 구성 요소가 있는지 확인하세요.
- 1x Brass Finish Ribbed Canopy (5" Diameter)
- 1x Mounting Strap/Crossbar
- 2x Mounting Screws (for outlet box)
- 2x Canopy Screws/Nuts (for securing canopy)
- 1x Ground Screw
- Wire Nuts (quantity may vary)
Image: The Satco 90-192 Brass Finish Ribbed Canopy Kit, showing the main canopy piece and associated hardware. This image illustrates the complete set of components included in the package, such as the canopy, mounting strap, and various screws.
설정 및 설치
Tools you may need (not included): Screwdriver (Phillips/Flathead), Wire Strippers, Pliers, Electrical Tape, Voltage 테스터.
- 전원 끄기: Locate the circuit breaker or fuse box that controls the power to the fixture location. Turn off the power completely. Use a voltage tester to confirm that the power is off at the outlet box.
- 장착 표면 준비: If replacing an existing canopy, carefully remove the old fixture. Ensure the electrical outlet box is securely mounted to the ceiling or wall structure.
- Install Mounting Strap: Attach the provided mounting strap (crossbar) to the electrical outlet box using the two mounting screws. Ensure the strap is firmly secured and the threaded holes for the canopy screws are facing outwards.
- 전기 연결을 만드십시오:
- Connect the bare copper or green ground wire from the fixture (if applicable) to the ground screw on the mounting strap.
- 전선 커넥터를 사용하여 조명기구의 흰색(중성) 전선과 콘센트 박스의 흰색(중성) 전선을 연결하십시오.
- 조명기구의 검은색(활선) 전선과 콘센트 박스의 검은색(활선) 전선을 전선 커넥터를 사용하여 연결하십시오.
- Ensure all wire nuts are securely twisted and connections are tight. Wrap electrical tape around wire nuts for added security if desired.
- Position Wires: Carefully tuck all connected wires into the outlet box, ensuring no wires are pinched.
- 캐노피 부착: Align the center hole of the canopy over the fixture's wires and the two threaded holes on the mounting strap. Push the canopy flush against the ceiling or wall. Secure the canopy in place using the two canopy screws/nuts, tightening them evenly until the canopy is snug.
- 복원력 : Once the canopy is securely installed, restore power at the circuit breaker or fuse box.
Image: A conceptual illustration of the canopy being installed onto a ceiling outlet box. This image demonstrates how the canopy covers the electrical connections and is secured by screws, providing a clean finish.
기능과 목적
The Satco 90-192 Brass Finish Ribbed Canopy Kit serves as a decorative and functional cover for the electrical wiring connections at the ceiling or wall outlet box. It provides a finished appearance to your lighting fixture installation while safely enclosing the electrical components. The 1-1/16" center hole accommodates the stem or chain of most standard lighting fixtures.
유지
To maintain the appearance and integrity of your brass finish ribbed canopy kit:
- 청소: Dust regularly with a soft, dry cloth. For more thorough cleaning, use a slightly damp cloth with mild soap and water. Avoid abrasive cleaners, solvents, or polishes that may damage the finish.
- 점검: Periodically check that the canopy remains securely fastened to the ceiling or wall. If any looseness is detected, turn off power and re-tighten the canopy screws.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| Canopy is loose or wobbles. | Canopy screws are not tightened sufficiently. | Turn off power. Re-tighten the canopy screws evenly until snug. Do not overtighten. |
| Canopy does not sit flush against the ceiling/wall. | Wires are not properly tucked into the outlet box; mounting strap is not flush. | Turn off power. Carefully re-arrange wires inside the outlet box. Ensure the mounting strap is flush with the outlet box. |
| 마감이 흐릿하거나 변색됩니다. | Accumulation of dust or residue; use of improper cleaning agents. | 부드러운 천으로 닦아주세요amp 천과 순한 비누. 가혹한 화학 물질을 피하십시오. |
명세서
- 상표: 샛코
- 모델: 90-192
- 재료: 놋쇠
- 마치다: Ribbed Brass
- 지름: 5인치
- Center Hole: 1-1/16 인치
- 장착 유형: 천장 마운트
- 한국어: 045923901928
보증 및 지원
This product is covered by Satco's standard manufacturer's warranty. For specific warranty details, claims, or technical support, please contact Satco customer service directly. Keep your purchase receipt as proof of purchase.
더 자세한 도움을 받으시려면 Satco 공식 웹사이트를 방문하십시오. web사이트를 방문하거나 고객 지원 센터에 문의하세요.
