1. 서론
The Generac 6346 30-Amp 125/250-Volt Power Inlet Box is designed for safe and reliable outdoor connection of a portable generator to an indoor transfer switch. This NEMA 3R-rated, corrosion-resistant aluminum enclosure ensures secure power transfer to your home or building during electrical outag에스.
This power inlet box is compatible with Generac generators equipped with 30-Amp outlets, including models such as GP3250, LP3250, XG4000, XP4000, GP5500, GP6500E, GP7500E, XG6500, XG7000E, XG8000E, XP6500E, and XP8000E. It is also compatible with Generac transfer switches model numbers 6376, 6377, 6378, 6379, and 6382.
Figure 1: Generac 6346 30-Amp Power Inlet Box.
2. 안전 정보
경고: 감전이나 화재의 위험이 있습니다.
- Installation of this power inlet box must be performed by a qualified, licensed electrician in accordance with all applicable electrical codes and standards.
- Do not attempt installation or wiring if you are not qualified. Improper installation can result in serious injury, death, or property damage.
- Always disconnect all power sources before installing or servicing the power inlet box.
- Ensure the generator is properly grounded before connecting it to the inlet box.
- Never operate a generator indoors or in enclosed spaces. Generators produce carbon monoxide, a colorless, odorless, poisonous gas.
3. 설정 및 설치
The Generac 6346 Power Inlet Box is designed for exterior mounting on a house or building. It must be hardwired to an appropriate indoor transfer switch.
3.1. 장착 위치
- Select an outdoor location that is easily accessible for generator connection but protected from direct impact.
- Ensure the location allows for proper routing of conduit and wiring to the indoor transfer switch.
- The NEMA 3R rating provides protection against rain, sleet, and external ice formation.
3.2. 배선 및 연결
- The inlet box features 1/2-inch and 3/4-inch EMT knockouts for conduit entry.
- Hardwire the inlet box to your transfer switch using appropriate gauge wiring for 30-Amp, 125/250V service.
- 모든 연결이 단단하고 안전한지 확인하세요.
Figure 2: Dimensions of the Generac 6346 Power Inlet Box (approximately 6.7 inches in height).
4. 사용 설명서
Once the Generac 6346 Power Inlet Box is professionally installed and wired to your transfer switch, follow these steps to operate your generator during a power outage:
- 위치 생성기: Place your portable generator outdoors in a well-ventilated area, away from windows, doors, and vents to prevent carbon monoxide accumulation.
- 전원 코드를 연결하십시오: Open the spring-loaded flip lid cover on the Generac 6346 Power Inlet Box. Connect a compatible Generac power cord (NEMA L14-30 configuration) from your 7500-Watt maximum generator to the inlet box. Ensure the connection is firm.
- 발전기 시작: Follow your generator's manufacturer instructions to start it. Allow the generator to run for a few minutes to stabilize.
- 전력 전송: Go to your indoor transfer switch and follow its instructions to safely transfer power from the utility to the generator.
- 모니터 부하: 발전기의 정격 와트를 초과하지 마십시오.tage (7500 Watts maximum for this inlet box).
- 종료: When utility power is restored, reverse the transfer switch procedure to switch back to utility power. Then, shut down your generator according to its manual and disconnect the power cord from the inlet box. Close the flip lid cover.
5. 유지관리
The Generac 6346 Power Inlet Box is constructed from NEMA 3R-rated corrosion-resistant aluminum, designed for durability and minimal maintenance. Regular inspection is recommended to ensure continued safe operation.
- 시각적 검사: Periodically inspect the inlet box for any signs of physical damage, corrosion, or loose components.
- 뚜껑 작동: Ensure the spring-loaded flip lid cover opens and closes smoothly and seals properly to protect the inlet from weather elements. If the lid mechanism appears faulty, inspect for obstructions or damage.
- 청소: Keep the exterior of the box clean from dirt, debris, and insect nests. Use a damp 청소용 천을 사용하고, 강한 화학 물질은 피하세요.
- 전문가 확인: Consider having a qualified electrician inspect your entire generator connection system periodically, especially after severe weather events.
6. 문제 해결
This section addresses common issues you might encounter with the Generac 6346 Power Inlet Box. Always ensure the generator itself is functioning correctly before troubleshooting the inlet box.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| No power to transfer switch after generator connection. |
|
|
| Flip lid cover does not close or open smoothly. |
|
|
| Visible damage to the inlet box. |
|
|
7. 사양
- 모델: 6346
- Amp나이: 30-Amp
- 권tage: 125/250V
- Maximum Generator Wattage: 7500 와트
- NEMA Configuration: L14-30
- 재료: 알류미늄
- 마감 유형 : 그린
- 설치 유형: 나사로 고정
- 치수(길이 x 너비 x 높이): 약 5 x 7 x 5인치
- 품목 무게: 약 1.6파운드
- 환경 등급 : NEMA 3R (Rain tight)
- 인증: UL 인증
- 원산지: 미국에서 제작
8. 보증 정보
The Generac 6346 30-Amp 125/250V Aluminum Power Inlet Box is backed by a 2년 한정 보증. This warranty covers defects in materials and workmanship under normal use and service. For full warranty terms and conditions, please refer to the official Generac warranty documentation included with your product or visit the Generac web대지.
9. 고객 지원
For technical assistance, warranty claims, or to inquire about replacement parts, please contact Generac Customer Service. Ensure you have your product model number (6346) and purchase date available when contacting support.
제너락 공식 Web대지: www.제네락닷컴
Note: Generac power inlet boxes should be installed by a professional electrician familiar with electrical wiring and code.
