1. 서론
The Genie GT912-1BL 9/12 Switch Remote Controller is designed to operate Genie garage door openers manufactured between 1980 and 1995 that utilize 9 or 12 dip switches. This remote provides a convenient way to control your garage door system. It is compatible with non-Intellicode openers only.
2. 안전 정보
Please read and understand all safety instructions before operating this remote control. Failure to follow these instructions may result in property damage, injury, or death.
- 리모컨은 어린이의 손이 닿지 않는 곳에 보관하십시오.
- 차고 문은 완전히 열렸을 때만 작동시키십시오. view막힘이 없고, 개폐 장치가 제대로 조정되어 있습니다.
- Never allow children to play with or operate the garage door controls.
- Ensure the garage door path is clear before activating the opener.
- Do not attempt to repair the remote control if it is damaged. Contact customer support.
3. 패키지 내용
패키지에 모든 품목이 들어 있는지 확인하세요.
- Genie GT912-1BL 9/12 Switch Remote Controller
- One 9V Alkaline Battery (pre-installed or included separately)
Image: The Genie GT912-1BL 9/12 Switch Remote Controller, showing its compact design and single button.
4. 설정 및 프로그래밍
The GT912-1BL remote is designed for easy programming by matching its internal dip switches to your existing remote or garage door opener unit.
- Locate Existing Dip Switches: Identify the dip switches on your existing Genie remote control or directly on the garage door opener power head unit. These switches are typically small, numbered, and can be set to 'ON', 'OFF', or 'MIDDLE' positions. Note the exact pattern of these settings.
- Access New Remote's Dip Switches: Open the battery compartment cover on the back of your new GT912-1BL remote controller. The dip switches will be visible inside.
- Match Switch Settings: Using a small screwdriver or pen, carefully adjust the dip switches on your new GT912-1BL remote to exactly match the pattern you observed on your existing remote or garage door opener unit. Ensure each switch is set to the correct 'ON', 'OFF', or 'MIDDLE' position.
- 배터리 설치 : If not already installed, insert the 9V battery into the compartment, observing the correct polarity (+/-).
- 덮개 닫기: 배터리함 덮개를 단단히 다시 닫으십시오.
- 테스트 작업: Stand within a reasonable range of your garage door opener and press the button on the new remote. The garage door should activate. If it does not, re-check the dip switch settings.
5. 사용 설명서
To operate your garage door:
- Ensure the garage door path is clear of any obstructions.
- 리모컨을 차고 문 개폐기 쪽으로 향하게 하세요.
- Press and release the large button on the remote control. The garage door will begin to open or close.
- Press the button again to stop the door's movement.
6. 유지관리
배터리 교체
The GT912-1BL remote uses one 9V alkaline battery. When the remote's range decreases significantly or it stops responding, it is likely time to replace the battery.
- 개방형 배터리 칸: Slide or unclip the battery compartment cover on the back of the remote.
- 오래된 배터리 제거: Carefully remove the old 9V battery.
- 새 배터리를 삽입하세요: Insert a new 9V alkaline battery, ensuring the positive (+) and negative (-) terminals are correctly aligned.
- 덮개 닫기: 배터리함 덮개를 단단히 다시 닫으십시오.
- 시험: Test the remote's operation to ensure it functions correctly with the new battery.
7. 문제 해결
-
원격이 작동하지 않음:
- Check the battery. Replace it if it is weak or dead.
- Verify that the dip switch settings on the remote exactly match those on your garage door opener or original remote.
- Ensure your garage door opener is a non-Intellicode model manufactured between 1980 and 1995. This remote is not compatible with newer Intellicode systems or very old systems operating on 325 MHz (modern systems typically use 390 MHz).
-
제한된 범위:
- 9V 배터리를 새 배터리로 교체하세요.
- Ensure there are no large metal objects or other sources of interference between the remote and the garage door opener.
8. 사양
| 모델 번호 | GT912-1BL |
| 호환성 | Genie non-Intellicode openers (1980-1995) with 9 or 12 dip switches |
| 배터리 유형 | 1 x 9V 알카라인(포함) |
| 권tage | 9 볼트 |
| 품목 무게 | 5.6 온스 |
| 제품 치수 | 1 x 7 x 8 인치 |
| 색상 | 검은색 |
| 특징 | 인체공학적 |
9. 보증 정보
This Genie GT912-1BL Remote Controller comes with a 1년 보증 from the date of purchase. This warranty covers defects in materials and workmanship under normal use. It does not cover damage caused by misuse, accidents, unauthorized repairs, or normal wear and tear. Please retain your proof of purchase for warranty claims.
10. 지원
For further assistance, technical support, or to inquire about warranty service, please visit the official Genie website or contact Genie customer service through their provided channels. Refer to your product packaging or the Genie web최신 연락처 정보는 사이트에서 확인하세요.
