XIGMATEK ARGB and PWM Remote Control Box
លក្ខណៈបច្ចេកទេស
ARGB & PWM Control Box Power Consumption
- 5V៖ សរុប 40W អតិបរមា
- 12V៖ សរុប 36W អតិបរមា
ការបញ្ជាពីចម្ងាយឥតខ្សែ
បើក/បិទ
LED Display Speed
របៀបបង្ហាញ LED
របៀបរង្វិលជុំដោយស្វ័យប្រវត្តិ
ពន្លឺបង្ហាញ LED
Rainbow Display Mode
LED Mode (White/Red/Green/Blue)
Fan Speed (Low/Medium/High)
ARGB & PWM Control Box
- FG PWM (Red Socket)
- 4 Pin PWM Port
- Pin ARGB Port
- SATA Power Cable (To PSU)
- MB Sync ARGB Cable Connect to ARGB Motherboard if Available
- Reset/LED Cable onnect to PC Case 2 Pin Button to Switch ED Display Mode
ការប្រុងប្រយ័ត្ន
- Please Do Not Over Power the ARGB & PWM Control Box, It Is Dangerous and Might Cause Damage!
- Please Check Your PSU 5V & 12V Power Output Specification, Make Sure PSU Single SATA Connector Can Support Sufficient Power Output to Avoid PSU Cable Overheat and Meltdown.
- Please Use at Least 450W PSU and 18AWG Thickness SATA Cable if Connect More Than 6 Fans.
- It Will Not Work with 4-Pin RGB or 12V RGB Fans or Light Strips.
សំណួរគេសួរញឹកញាប់
What is the purpose of the FG PWM socket?
The FG PWM socket is used to enable the fan speed feedback function.
What power supply should I use with this control box?
Use at least a 450W PSU and 18AWG thickness SATA cable if connecting more than 6 fans.
How can I synchronize the lighting with my motherboard?
Use the MB Sync ARGB Cable to connect to an ARGB motherboard if available.
ឯកសារ/ធនធាន
 |
XIGMATEK ARGB and PWM Remote Control Box [pdf] ការណែនាំអ្នកប្រើប្រាស់ ARGB and PWM Remote Control Box, PWM Remote Control Box, Remote Control Box, Control Box |