Shenzhen Zhengyi Technology ZY02 Tpms Tire Pressure Monitoring System Series
ព័ត៌មានអំពីផលិតផល
លក្ខណៈពិសេស៖
- Power Supply: Solar charging and USB charging
- Sensors: 6 or 4 sensors included
- Weather Resistance: Suitable for all weather conditions
- Function: Measure pressure and temperature with high sensitivity and precision
Tire Pressure Manual
- Tire pressure monitoring system (TPMS) can monitor tire pressure/temperature status in real time. It will transmit real-time voice alarms and flashing warning lights, reminding drivers of the comfort and driving safety of the vehicle.
- imultaneously display tire pressure and temperature.
- Air leakage warning, low pressure warning, and high pressure warning.
- High temperature warning, low power warning, and no signal warning.
ជួរធំទូលាយនៃកម្មវិធី
This system is widely applicable to vehicles with 6 or more tires, with a maximum tire pressure below 8 or 15 BAR, Such as commercial vehicles, RVs, small trucks, etc.
ការបង្ហាញឌីជីថល៖
LCD display screen, bright backlight, clear data, allowing you to easily and comfortably understand the status of your car.
ការផ្គត់ផ្គង់ថាមពល៖
It supports solar charging and USB charging, which means our TPMS device can be used in all weather conditions, very convenient.
-6 or 4 sensors:
We offer 6 or 4 sensors, suitable for use in rainy weather. In addition, they have high sensitivity and precision, which can be used to measure pressure and temperature.
TPMS receiver:
- Battery: Built in 800mAh lithium-ion battery
- វ៉ុលធ្វើការtagអ៊ី: ឌីស៊ី ៥ វី
- RF transmission frequency: 2402 – 2480 MHz
- Pressure unit: psi/bar
- Temperature unit: Deg. C/Deg. F
- Working temperature: minus 20 plus 85 degrees Celsius
- Storage temperature: minus 40 to plus 85 degrees Celsius.
ឧបករណ៍ចាប់សញ្ញាខាងក្នុង
- Work pressure: 0-8 bar/0-15 bar
- Pressure accuracy: ± 0.1BAR
- ប្រេកង់បញ្ជូន: 2402-2480MHz
- Antenna: TSLBT antenna
- ការទទួលបានអង់តែន: 2.10 DBi
- Impedance: 50R
- ប្រេកង់៖ ២៤០២-២៤៨០ MHz
- Working temperature: minus 40 to plus 125 degrees Celsius
- Storage temperature: minus 40 to plus 125 degrees Celsius
- វ៉ុលធ្វើការtagអ៊ី: ៤.៨-១០ វី
- កម្រិតការពារទឹកជ្រាប៖ IP67
- Battery: Built in CR24.5 million button battery
- អាយុកាលថ្ម៖ ៥-៨ ឆ្នាំ។
ឧបករណ៍ចាប់សញ្ញាខាងក្រៅ
- Work pressure: 0-8bar/0-15bar
- Pressure accuracy:+/-0.1BARi
- ប្រេកង់ប្រតិបត្តិការ: 2402-2480MHz
- Antenna: TSLBT antenna
- ការទទួលបានអង់តែន: 2.10 DBi
- Impedance: 50R
- ប្រេកង់៖ ២៤០២-២៤៨០ MHz
- វ៉ុលធ្វើការtagអ៊ី: ៤.៨-១០ វី
- មិនជ្រាបទឹក: IP67
- Working temperature: minus 40 to plus 125 degrees Celsius
- Storage temperature: minus 40 to plus 125 degrees Celsius
- ថ្ម៖ ថ្មប៊ូតុង CR1632
- Battery life: 1-2 years (replaceable battery)
Host setting instructions
- Switching between 1, 4 or 6 wheel modes
- Press and hold the middle button for 3 seconds to enter the settings interface. Display 0 in the upper left corner, switch between 4-wheel mode or wheel mode in this mode. Press the middle button (used in the factory), it will flash 6 times. Press the left button to switch, and then press the middle button to confirm. Long-press the button on the right to exit the settings mode.
- Switching of air pressure units
- Long-press the middle button for 3 seconds to enter the settings interface, short-press the right button once, and 1 will be displayed in the upper left corner. In this mode, switch the air pressure unit. Press the middle button, the air pressure unit will flash. Press the left button to switch, and then press the middle button to confirm. Long-press the button on the right to exit the settings mode.
- ការផ្លាស់ប្តូរឯកតាសីតុណ្ហភាព
- Long-press the middle button for 3 seconds to enter the settings interface, short-press the right button twice, and 2 will be displayed in the upper left corner.
- Switch temperature units in this mode. Press the middle button, the temperature unit will flash, press the left button to switch, and press the middle button to confirm. Long-press the button on the right to exit the settings mode.
- Front wheel high-pressure alarm value setting Long press the middle button for 3 seconds to enter the settings interface, short-press the right button 3 times, and 3PH will be displayed in the upper left corner. Set the front wheel high pressure alarm value in this mode. Short-press the middle button, and the pressure value will flash. Press the left button to decrease, press the right button to increase, and press the middle button to confirm. Long-press the button on the right to exit the settings mode.
- Setting of low-pressure warning value for the front wheels Long Long-press the middle button for 3 seconds to enter the settings interface, short-press the right button 4 times, and 4PL will be displayed in the upper left corner Set the front wheel low-pressure alarm value in this mode. Short-press the middle button, and the pressure value will flash. Press the left button to decrease, press the right button to increase, and press the middle button to confirm. Long-press the button on the right to exit the settings mode.
Rear wheel high pressure alarm value setting
- Long press the middle button for 3 seconds to enter the settings interface, short press the right button 5 times, and the top left corner will display 5.
- Set the rear wheel high pressure alarm value in this mode.
- Short press the middle button, the pressure value will flash.
- Press the left button to decrease, press the right button to increase, and press the middle button to confirm.
- Long-press the button on the right to exit the settings mode.
- Setting of low pressure warning value for rear wheels Long press the middle button for 3 seconds to enter the settings interface, short-press the right button 6 times, and the top left corner will display Set the rear wheel low-pressure alarm value in this mode.
- Short-press the middle button, the pressure value will flash.
- Press the left button to decrease, press the right button to increase, and press the middle button to confirm.
- Long-press the button on the right to exit the settings mode.
- Temperature alarm value setting Long Long-press the middle button for 3 seconds to enter the settings interface, short-press the right button 7 times, and the top left corner will display 7.
- Set the temperature alarm value in this mode. Press the middle button, the temperature value will flash. Press the left button to decrease, press the right button to increase, and press the middle button to confirm. Long-press the button on the right to exit the settings mode.
របៀបផ្គូផ្គង
Long-press the middle button for 3 seconds to enter the settings interface, short-press the right button 8 times, and the top left corner will display 8. Pairing settings can be made in this mode.
- Press the middle button twice to enter the fully paired state. Press the left front, right front, and back buttons in sequence to pair. After 6 successful pairings, press the middle button to confirm. Long-press the button on the right to exit the settings mode.
- Press the middle button briefly once, and the number below will flash. Press the left and right buttons to select the tire position you want to pair with. After successful pairing, press the middle button to confirm. Long-press the button on the right to exit the settings mode.
ស្តារការកំណត់របស់រោងចក្រឡើងវិញ
Long-press the middle button for 3 seconds to enter the settings interface. Short-press the right button 9 times, and the top left corner will display 9. In this mode, the factory settings will be restored. Short-press the middle button, and NO/YES will be displayed at the bottom. Press the left and right buttons to switch, and press the middle button to confirm.
សំណួរគេសួរញឹកញាប់
How do I know if the sensors are working properly?
The TPMS receiver will display real-time data from the sensors. If there are any issues with the sensors, an alert will be shown on the receiver.
Can I use the TPMS device in extreme weather conditions?
Yes, the TPMS device is designed to be used in all weather conditions, including rainy weather.
ឯកសារ/ធនធាន
 |
Shenzhen Zhengyi Technology ZY02 Tpms Tire Pressure Monitoring System Series [pdf] សៀវភៅណែនាំអ្នកប្រើប្រាស់ ZY02, 2BS6M-ZY02, Tpms Tire Pressure Monitoring System Series, Tpms Tire Pressure Monitoring System Series, Tpms, Tire Pressure, Monitoring System, Series |