Klingeltaster / Push button Combifix
Installation
⚠️ Safety Notice:
DE: Montage muss im spannungslosen Zustand durch eine Elektrofachkraft erfolgen!
EN: Installation must be carried out in deenergized condition by an electrical!
Installation Steps
Step 1: Open the casing
Shows a hand using a tool to open the casing of the push button.
Original text: Gehäuse öffnen Open the casing
Step 2: Wall fixation (Dist. 32mm)
Illustrates fixing the push button to a wall mount using screws, with a 32mm distance indicated.
Original text: Festschrauben (Dist. 32mm) Wall fixation (Dist. 32mm)
Step 3: Strip the wires (6mm)
Depicts wires being stripped to a length of approximately 6mm using a wire stripper.
Original text: Drähte abisolieren (6mm) Strip the wires (6mm)
Step 4: Connect wires
Shows wires being connected to the push button's terminals, labeled C and 0.
Original text: Drähte anschließen Connect wires
Diagram representation: [terminal C], [terminal 0]
Step 5: Insert name plate, close cover
Illustrates inserting a name plate into the designated slot and then closing the cover of the push button.
Original text: Namensschild einlegen, schließen Insert name plate, close cover
Step 6: Combinat. several pushes
Shows how to connect multiple push buttons together for combined functionality.
Original text: Anreihung mehrerer Taster Combinat. several pushes
Step 7: Remove 2 ribs in the base
Depicts removing two small plastic ribs from the base of the unit, likely for specific mounting or wiring configurations.
Original text: 2 Stege im Unterteil entfern. Remove 2 ribs in the base
Step 8: Connect wires etc.
Shows final wire connections, possibly for additional features like LEDs or options.
Original text: Drähte anschließen etc. Connect wires etc.
Diagram representation: [terminal C], [terminal 0], [LED / Option]
Wiring Diagram
The wiring diagram illustrates the connection of two push buttons (Taster/Push 1 and Taster/Push 2) to a transformer. The transformer is specified as SELV (Safety Extra-Low Voltage) compliant with Norm EN61558-2-6/-2-8 and operates on 8-12V~.
Each push button has two main terminals, typically labeled C (Common) and 0 (Normally Open or connection to ground/neutral). The diagram shows the transformer's positive output connecting to the C terminals of both push buttons. The 0 terminals of both push buttons are connected together and then to the transformer's negative/return path.
Activating a push button is shown to trigger a sound output, indicated by 'Ding' and 'Dong' symbols. Push button 1 is associated with 'Ding' and 'Dong 1', while Push button 2 is associated with 'Ding' and 'Dong 2'.
Additional connections are shown for an 'LED / Option' terminal on Push button 2.
Technical Data
- Voltage: 8 - 12 V ~ (AC 5 mA - 1.5 A)
- Voltage: 8 - 12 V = (DC 5 mA - 1.0 A)
- Safety: Only Protective Extra-Low Voltage (SELV)! Protect. low volt. only!
- Wire Gauge: 0.6 - 0.8 mm
- Operating Temperature: -20°C to 60°C
- Ingress Protection: IP41
- Operating Force: Approx. 6 N
Manufacturer Information
Grothe GmbH
Löhestraße 22
53773 Hennef
Email: service@grothe.de
Brand: GROTHE URMET GROUP
Document Reference: MV 510130, 02/23
