Videx VLF-H035C LED Rechargeable Headlamp - User's Manual

1. Specifications

2. Product Overview

Diagram showing the Videx VLF-H035C headlamp with labels pointing to: 2.1 ON/OFF button, 2.2 Sensor button, 2.3 Main light (central LED), 2.4 COB light (side strip), 2.5 Red light (small LED), 2.6 Battery indicator (multiple LEDs), and 2.7 Charging port (USB-C).

• 2.1 ON/OFF button
• 2.2 Sensor button
• 2.3 Main light
• 2.4 COB light
• 2.5 Red light
• 2.6 Battery indicator
• 2.7 Charging port

3. Operating Instructions

Main Light: Press the ON/OFF button to turn the main light on, cycle through lighting modes (HIGH, LOW, FLASH), and turn it off. If the light has been on for more than 5 seconds, a short press of the button will turn it off.

COB Light: Press and hold the ON/OFF button for 0.5 seconds to turn the COB light on. Repeat the same action to turn it off.

Sensor Function:

• To activate the sensor in the current mode: Select your preferred lighting mode, then press the SENSOR button to save it. Wave your hand near the front of the headlamp to turn it on or off.
• To activate the sensor in the last saved mode: Press the SENSOR button while the light is off.
• To deactivate the sensor: Press the SENSOR button again.

Locking/Unlocking: With the light off, press and hold both buttons for 3 seconds to lock the headlamp. Repeat the same action to unlock it.

Memory Function: The headlamp automatically remembers the last selected lighting mode and reactivates it the next time it is turned on.

4. Charging

Turn off the headlamp and open the protective silicone cover. Connect the USB-A end of the charging cable to a wall charger and the other end to the headlamp's USB-C charging port. During charging, the indicator segments will blink to show the current battery level. When the battery is fully charged, all segments will remain steadily lit. After charging is complete, unplug the charging cable and close the protective cover to prevent water and dust ingress.

5. Battery Indication

To check the battery level when the light is off, press and hold the SENSOR button. The battery level will be displayed for 2 seconds. When the light is on, the battery level is displayed continuously. Diagram illustrating the battery indicator, showing five LED segments. When all five segments are lit, the battery is fully charged. Each segment represents approximately 20% of the battery level.

6. Box Contents

• 6.1 Headlamp
• 6.2 Headband
• 6.3 Charging cable
• 6.4 User's manual
• 6.5 Warranty card

7. Maintenance

The rechargeable battery inside the headlamp is not user-replaceable. Disassembling the sealed body may compromise the headlamp's performance and void the warranty. To maintain optimal performance of the Li-Pol battery, recharge the stored headlamp every four months.

8. Warnings

• High-intensity light can cause eye damage. Avoid shining it directly into anyone's eyes.
• Keep this headlamp out of reach of children.
• The LED light source inside this headlamp is non-replaceable. When the LED reaches the end of its service life, the entire headlamp should be replaced.
• The manufacturer is not responsible for any damage resulting from failure to follow these instructions.
• The manufacturer reserves the right to make changes to the manual. The current version can be downloaded from the website.

9. Warranty

The warranty for the headlamp is 2 years. The warranty does not cover accessories. During the warranty period, a faulty headlamp can be exchanged or returned with proof of purchase and all accessories saved. The warranty does not cover: Misuse of the product causing damage to integral components; Unauthorized disassembly or deep mechanical damage; Damage due to force majeure.

Compliance and Manufacturer Information

The product complies with the technical regulations of Ukraine and meets the requirements of EU directives.

Environmental protection: It is forbidden to dispose of the product together with general waste. Used or damaged products should be disposed of in accordance with the Directive on Waste Electrical and Electronic Equipment (WEEE). Contact your local recycling organization for more details.

Production date and batch number are indicated on individual packaging. Product materials: aluminum, tempered glass.

Producer: Allegro-opt PE, 106-ZH Heroiv Mariupolia, Kropyvnytskyi, 25004, Ukraine. Made in China.