Sharp Microwave Oven Certification Details

INFORMATION FOR CERTIFICATION (1)

APPLICANT:

Name

Sharp Corporation, Reliability Control Group

Address

22-22 Nagaike-Cho, Abeno-Ku, Osaka 545-8522, Japan

Grantee Code

APY

Applicant Rep.

H. Nishira

CONTACT PERSON:

Name

Sharp Electronics Corporation

Address

Sharp Plaza, Mahwah, New Jersey 07430

Applicant Rep.

Steve Petruska, Product Safety Dept.

Telephone No.

201-529-9689

MEASUREMENT SITE:

Name

Japan Quality Assurance Organization, Chubu Testing Center, Shikatsu Branch

Address

53-1, Yamaura, Yakushiji, Shikatsu-cho, Nishikasugai-gun, Aichi 481-0005, Japan

MANUFACTURER:

Name

Sharp Appliances (Thailand) Ltd.

Address

64 Moo 5, Tambol Bangsamuk, Amphur Bangpakong, Chachoengsao Province, Thailand

FCC IDENTIFICATION

APYDM R0147

EQUIPMENT:

Model Name

Microwave Oven Model R-209K#, R-220K# and R-230K# (#: Suffix letter denoting cosmetic color is provided.)

Brand

Sharp Electronics Corp.

Importer

Sharp Electronics Corp.

INFORMATION FOR CERTIFICATION (2)

• Type(s) of emission: Not Applicable
• Frequency range: 2450 MHz
• Range of operating power and description of means provided for variation of operating power: RF output power 800 W (Average power output is controlled by ON/OFF switching cycles.)
• Max. power rating as described in the applicable rules: 800 W
• The voltage and current to magnetron:
  • Magnetron Cat. No. 2M216J(L): 3.60 kV peak, 235 mA
  • Magnetron Cat. No. 2M211A-M1: 3.72 kV peak, 235 mA
• Function of each electro tube, semiconductor or other active circuit device: Fixed Magnetron, Type 2M216J(L) or 2M211A-M1 as power generator
• Complete circuit diagram: Attached
• Instruction book: Attached
• Tune up procedure over the power range or at specific operating power levels: Not adjustable
• A description of all circuitry and devices provided for determining and stabilizing frequency: Fixed by magnetron and oven design
• A description of any circuit or devices employed for suppression of spurious radiation, for limiting modulation, and for limiting the operating power: Suppression obtained by shielding design
• Identification plate or label: Illustration attached
  Location of identification plate or label: Photo. Attached

INFORMATION FOR CERTIFICATION (3)

DESCRIPTION OF THE MICROWAVE OVEN

Unit Body Dimensions

460 mm wide, 275 mm high, 358 mm deep (include feet)

Door Dimensions

360 mm wide, 252 mm high (Viewing Area: 233 mm wide, 122 mm high)

Oven Cavity Dimensions

319 mm wide, 226 mm high, 336 mm deep (without tray)

Feed Type and Location

Supplied by waveguide located side of oven

Door Seal Type

Choke and Capacitive Seals

Magnetron Type

2M216J(L) mfd by Toshiba; or 2M211A-M1 mfd by Matsushita