Sharp Corporation DMR0135 Household Microwave Oven APYDMR0135 APYDMR0135 dmr0135
********** INFORMATION FOR CERTIFICATION (1) ********** APPLICANT: Name Address Grantee Code: Applicant Rep. : Sharp Corporation, Reliability Control Group 22-22 Nagaike-Cho, Abeno-Ku Osaka 545-8522, Japan : APY : S. Miyasaka CONTACT PERSON: Name Address Applicant Rep. Telephone No. : Sharp Electronics Corporation : Sharp Plaza, Mahwah, New Jersey 07430 : Steve Petruska, Product Safety Dept. : 201-529-9689 MEASUREMENT SITE: Name Address : Japan Quality Assurance Organization Kita-Kansai Testing Center, EMC Division : 7-1 Ishimaru 1-Chome Minoh-shi, Osaka 562-0027, Japan MANUFACTURER: Name Address : Sharp Appliances (Thailand) Ltd. : 64 Moo 5, Tambol Bangsamuk Amphur Bangpakong Chachoengsao Province, Thailand FCC IDENTIFICATION : APYDMR0135 EQUIPMENT Model Name Brand Importer : Microwave Oven Model R-202E#, R-203E# and R-215E# (#: Suffix letter denoting cosmetic color is provided.) : Sharp Electronics Corp. : Sharp Electronics Corp. ----------------------------------------------------------------------------------------------------------------------------------------- ********** INFORMATION FOR CERTIFICATION (2) ********** (1) Type(s) of emission: Not Applicable (2) Frequency range: 2450 MHz (3) Range of operating power and description of means provided for variation of operating power: RF output power 700 W (Average power output is controlled by ON/OFF switching cycles.) (4) Max. power rating as described in the applicable rules: 700 W (5) The voltage and current to magnetron: Magnetron Cat. No. 2M213 : 3.68 kV peak, 230 mA (rms) (6) Function of each electro tube, semiconductor or other active circuit device: Fixed Magnetron, Type 2M213 as power generator (7) Complete circuit diagram: Same as that of previously reported model. (8) Instruction book: Same as that of previously reported model. (9) Tune up procedure over the power range or at specific operating power levels: Not adjustable (10) A description of all circuitry and devices provided for determining and stabilizing frequency: Fixed by magnetron and oven design (11) A description of any circuit or devices employed for suppression of spurious radiation, for limiting modulation, and for limiting the operating power: Suppression obtained by shielding design (12) Identification plate or label: Same as that of previously reported model. Location of identification plate or label: Same as that of previously reported model. ********** INFORMATION FOR CERTIFICATION (3) ********** DESCRIPTION OF THE MICROWAVE OVEN Unit Body Dimensions : 460 mm wide, 276 mm high, 352 mm deep (include feet) Door Dimensions : 368 mm wide, 252 mm high (Viewing Area: 239 mm wide, 122 mm high) Oven Cavity Dimensions : 321 mm wide, 225 mm high, 336 mm deep (without tray) Feed Type and Location : Supplied by waveguide located side of oven Door Seal Type : Choke and Capacitive Seals Magnetron Type : 2M213, mfd by LG ElectronicsAcrobat Distiller 4.05 for Windows 9.0