FEIG MWD SBP R-Loop Radar Scanner
លក្ខណៈបច្ចេកទេស
- Product Name: MWD SBP (R-Loop)
- Device Family: Radar scanners
- ក្រុមហ៊ុនផលិត៖ FEIG ELECTRONIC GmbH
- កាលបរិច្ឆេទ៖ ១៤.០៨.២០២៣
ការណែនាំ
MWD SBP (R-Loop) Teaching a barrier boom with an accessory installed (hanging lattice/ climb protection/pendulum support) or a folding barrier boom
Device family: Radar scanners
ប្រធានបទ
- The MWD SBP offers the option of blanking out a hanging lattice, climb protection, or a pendulum support so that these are not detected as obstacles when the barrier is closing. If a boom accessory is used, it is essential to teach the movement of the barrier boom, including the boom accessory, to ensure that the barrier functions reliably! This process may also be necessary for folding barrier booms under certain circumstances.
ការកំណត់កម្រិតខ្ពស់
- After completing the basic configuration of the radar scanner using the configuration assistant, you will then have the option of configuring advanced settings (menu point 7/7). Please select the step ‘Teach-in barrier boom’ from the submenu of the advanced configurations.
សូមចំណាំ
- Before starting the teach-in process, please ensure that you can control the barrier (OPEN/CLOSE) without being within the detection range of the radar scanner (key switch, hand-held transmitter, push button and cable, etc.). Optionally, you can also operate the barrier via the app by setting the corresponding outputs during the teaching process. This requires that the outputs have been wired accordingly.
- ការយកចិត្តទុកដាក់៖ Safety is deactivated during the teach-in process! Please be sure to follow the instructions in the app.
To teach the boom accessory / folding boom, please proceed as follows:
- Create a way to control the barrier remotely (remote control, key switch, push button, cable, etc.)
- Open the barrier and leave the detection range of the radar scanner. Ideally, please stand behind the barrier. If necessary, it may be useful for the teach-in process to set the automatic closing time of the barrier to 5-10 seconds.
- Press ‘Start teach-in’ as soon as you have left the detection area. Be sure to follow the instructions in the app.!
- Close the barrier and then open it again. Repeat this process 2-3 times.
- End the learning process manually by tapping ‘End teach-in’.
The boom accessory / the folding barrier boom is no longer recognised as an obstacle. The status now updates to ‘Environment was teached-in’:
There are also advanced settings for teaching the barrier boom. In the advanced settings, you can adjust the tolerance of the radar scanner in relation to the boom accessory. The higher the tolerance, the larger the area that is blanked out around the barrier boom. Please note that a high tolerance leads to a reduction in safety! When is a high tolerance necessary? For example, in strong winds that cause the barrier boom to sway randomly. However, this depends on the actual construction of the suspended lattice and its stability. For the best operation, the hanging lattice should be anchored to the barrier cabinet to reduce the horizontal movement in windy locations. The tolerance can be adjusted retrospectively without having to re-teach the barrier boom!
ការយកចិត្តទុកដាក់
- Teaching in the barrier boom does not influence teaching the environment (menu point 6/7). These two teach-in processes must be carried out independently of each other. Furthermore, the configurations do not influence each other and have completely independent functions.
ព័ត៌មានបន្ថែម
- FEIG អេឡិចត្រូនិក GmbH
- Industriestraße 1a, 35781 Weilburg, អាល្លឺម៉ង់
- ទូរស័ព្ទ 06471/3109-0
សំណួរគេសួរញឹកញាប់
Q: Is it necessary to repeat the teach-in process for the barrier boom accessory?
A: Yes, it is recommended to repeat the process 2-3 times to ensure accurate detection avoidance.
Q: Can the barrier boom accessory be taught in without a remote control?
A: No, a way to control the barrier remotely is needed for the teach-in process.
ឯកសារ/ធនធាន
 |
FEIG MWD SBP R-Loop Radar Scanner [pdf] សេចក្តីណែនាំ MWD SBP R-Loop Radar Scanner, MWD SBP, R-Loop Radar Scanner, Radar Scanner, Scanner |