EPIC MARKS UV DTF Application
លក្ខណៈបច្ចេកទេស
- ឈ្មោះផលិតផល៖ UV DTF Decal Transfer Film
- ក្រុមហ៊ុនផលិត៖ Epic Marks
- អាស័យដ្ឋាន៖ 418 Chisholm Valley Drive, Round Rock, TX 78681
- ទំនាក់ទំនង៖ ៨៦៦-៤៤៧-២១៩៤ | orders@epicmarks.com
សេចក្តីណែនាំ
Clean Your Surface
Start with a squeaky-clean surface. Wipe it down with isopropyl alcohol and a lint-free cloth, then let it dry. If there’s oil, dust, or even a smudge left behind, the adhesive won’t grab.
Prepare the Transfer
Flip the decal over and slowly peel away the white paper backing. The design should stay on the clear sheet. If a piece doesn’t lift, lay the backing back down, rub that area, and try again.
Position The Decal
Line it up on your item exactly where you want it. UV DTF is sticky—take your time. (If you’re nervous, the soap + water hack below gives you a little wiggle room.)
Press it Down
Use a squeegee or a credit card and rub firmly across the entire design. Start in the center and push outward to work out air and make sure every edge is sealed.
Peel the Film
Slowly peel back the clear sheet, keeping it low and steady. The design should stay behind, glossy and slightly raised. If an edge lifts, lay the film back down, squeegee that spot again, and re-peel.
គន្លឹះជំនួយ: Mist the surface lightly with soapy water before you position the decal. This lets you slide it into place. Once it’s lined up, squeegee the liquid out and let it dry overnight before peeling the film.
Got bubbles?? Squeegee firmly working from the center out – or pop with a small pin and smooth flat.
អាដវ៉ានtages of UV‑DTF via Epic Marks
- No Heat Press Needed at Application: Once the decal is printed and cured, you can apply it without a heat press.
- Versatility of Substrates: Works well on a wide range of non-porous materials: metal, glass, plastic, coated wood, etc.
- High Detail and Vibrant Color: Because UV inks cure instantly, you can get sharp edges and very vivid color.
- Longer Shelf Life of Transfers: You can print a full gang sheet of decals and store them for later use.
- ភាពស្អិតជាប់ខ្លាំង៖ When applied properly, they adhere very well to smooth, hard surfaces.
Care & Durability
- ការបោកគក់៖ Hand-wash only. Avoid dishwashers, abrasive sponges, or harsh chemicals.
- លក្ខខណ្ឌប្រើប្រាស់៖ Because the decal is somewhat raised and glossy, too much abrasion may damage it.
- ធន់៖ The UV‑cured ink and adhesive are quite durable, but their lifespan depends on surface, use, and care.
Visit us online for full guide www.epicmarks.com
សំណួរគេសួរញឹកញាប់
Can I reposition the decal after applying it?
It is recommended to position the decal carefully during application as repositioning may damage the adhesive.
How long should I let the decal dry before peeling off the film?
It is advised to let the decal dry overnight to ensure proper adhesion before removing the film.
ឯកសារ/ធនធាន
 |
EPIC MARKS UV DTF Application [pdf] សេចក្តីណែនាំ UV DTF Application, Application |