ALL COMPUTER RESOURCES ECU Electronic Control Module

លក្ខណៈបច្ចេកទេស

• ឈ្មោះផលិតផល: Electronic Control Module (ECM)
• ម៉ូឌុលដែលគាំទ្រ៖ ECU, ECM, PCM, TCM, FICM, IDM, FCM, BCM
• ក្រុមហ៊ុនផលិត៖ ធនធានកុំព្យូទ័រទាំងអស់។

ការដំឡើង

Installing an ECM yourself is pretty easy. This guide lists the proper way to install an ECM when you have purchased a pre-programmed, “plug and play” ECM from All Computer Resources. Failure to fix and/or replace any bad components or connections within the vehicle can damage the new ECM and void the warranty. ECMs rarely fail on their own. Please perform any necessary repairs before installation.

Before installing ECM, make sure that

• នេះ។ ថ្ម is charged at over 12V
• The wiring harness is clean and in good condition
• Any known defective parts have been replaced
• All ground connections are in good condition and tightly secured
• Read and follow TechTalk bulletins ACR001-ACR003

ECM Installation

1. Disconnect the Negative terminal from the battery
2. Let the vehicle sit for thirty (30) minutes unplugged
3. Install the new ECM (Be sure the connectors are inserted firmly)
4. Connect ground wires back to ECM (If applicable)
5. ភ្ជាប់ថ្មឡើងវិញ
6. Turn the key to the RUN position (do not start). At this point, the “Check Engine is O, which means the ECM is working. – Leave in this position for 5 minutes
7. បង្វែរភ្លើងទៅទីតាំងបិទ
8. Turn the ignition ON and start car

ចំណាំ៖ Note: If you are experiencing drivability issues, please refer to Tech Talk bulletins ACR004 & ACR006. If your Check engine light stays illuminated, reset codes and follow the installation again. If the codes remain, the ECU is notifying you that there are issues with the vehicle that must be corrected.

Core Return: To activate the warranty and avoid a core charge, return the core within 14 days.

សំណួរគេសួរញឹកញាប់

What should I do if the Check Engine light remains on after installation?

Reset the codes and repeat the installation process. If the issue persists, there may be underlying vehicle problems that need to be addressed.

How long do I have to return the core to activate the warranty?

The core must be returned within 14 days of installation to activate the warranty and avoid any core charges.

ឯកសារ/ធនធាន

ALL COMPUTER RESOURCES ECU Electronic Control Module [pdf] ការណែនាំអំពីការដំឡើង ECU Electronic Control Module, Electronic Control Module, Module

ឯកសារយោង

• សៀវភៅណែនាំអ្នកប្រើប្រាស់