Klipsch Synergy Black Label B-100 Bookshelf Speaker Pair with Proprietary Horn Technology
Specifications
- DIMENSIONS: 75” H X 5.88” W X 7.5” D
- WEIGHT:13 pounds
- OUTPUT WOOFER SIZE: 4”
- TWEETER SIZE:75”
- FREQUENCY RANGE: 64Hz-23KHz ± 3dB.
- BRAND: Klipsch
Introduction
Klipsch Synergy Bookshelf speakers work as front speakers or surround speakers. They provide accurate and high-quality sound which is non-fatiguing. These speakers come with a dynamic 0.75 inches tweeter, and a single 4 inches high-output woofer. These speakers are highly efficient, with minimal distortion, and provide lifelike, precise, and wide sound. These speakers have a very decent design which looks amazing and blends in with any décor. These have a small size and fit most of the spaces without any issue.
IMPORTANT SAFETY INSTRUCTIONS
- READ these instructions.
- KEEP these instructions.
- HEED all warnings.
- FOLLOW all instructions.
- DO NOT use this apparatus near water,
- CLEAN ONLY with dry cloth.
- DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- ONLY USE attachments/accessories specified by the manufacturer.
- USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold With the apparatus. When a cart IS used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.
- DO NOT expose this apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.
- The exclamation point, within an equilateral triangle, is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
- The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons.
WARNING
To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture.
WARNING
No naked flame sources — such as candles – should be placed on the product.
ROOM PLACEMENT
Before You Start
Your Klipsch B-l O speakers have rubber feet that can be installed prior to use, Refer to Figure I, They also have keyhole mounts on the rear that allow you to wall-mount them. Refer to Figure 2.
Left and Right Main Channel Speakers
For optimum performance, Klipsch suggests placing your speakers six to 15 feet (2 to 4.5m) apart and at least 24 inches (60.8cm) from the back and side walls. Their height should be at ear height of a seated listener. They may also be toed in slightly for better stereo imaging. The listening position should be about 1 to 1.5 times the distance separating the speakers. Refer to Figure 3.
CONNECTING
Conventional Connection
Using a 16-gauge or larger speaker wire, connect the RED “positive” (+) terminal of the LEFT speaker to the RED “positive” (+) terminal of your amplifier’s LEFT channel. Connect the BLACK “negative” (—) terminal of the LEFT speaker to the BLACK “negative” (—) terminal of your amplifier’s LEFT channel. Repeat this procedure for connecting the remaining speaker to the appropriate amplifier channel, Refer to Figure 4. Make sure that no bare wires from any of the connections touch any other terminals as this could cause a short and damage your equipment.
Amplifier Requirements
Klipsch speakers are highly efficient and will operate easily on a wide variety of amplifiers. All Klipsch speakers are 8-ohm compatible and can be driven to very high levels with low distortion. Due to the high output levels, Klipsch speakers are capable of reproducing, exercise caution with the volume control. Excessive volume over long periods can permanently damage your hearing. Overdriving your amplifier could also damage your speakers. Check with your dealer to make sure your particular amplifier is best suited to your application. We want you to listen for a lifetime.
CARE AND CLEANING
The only thing you should ever need to do to your speakers is dusted them occasionally. Never apply any abrasive or solvent-based cleaner or any harsh detergent, You can clean the grilles with the brush attachment of a vacuum cleaner.
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark, Conforms to European Union EMC Directive 2004/108/EC,
WEEE NOTICE
Note
This mark applies only to countries within the European Union (EU) and Norway.
This appliance is labeled in accordance with European Directive 2002/96/EC concerning waste electrical and electronic equipment (WEEE). This label indicates that this product should not be disposed of with household waste. It should be deposited at an appropriate facility to enable recovery and recycling.
PRODUCT REGISTRATION
Register your product online at www.klipsch.com/register
- Klipsch will keep you up-to-date on new products and promotions.
- Your personal information will never be resold.
- This registration information is not used for warranty purposes.
Please retain your receipt for warranty claims.
Bookshelf Speakers
Wall Mount Surround Speakers
Speaker Placement in Listening Area
Standard Connections
FREQUENTLY ASKED QUESTIONS
- Is this for a single speaker or pair?
These speakers usually come in pairs. - Watts handling capability?
The speakers have a watt handling capacity of 200W peak and an RMS of 50W. The speakers have an impedance of 8 ohms. - Are these magnetically shielded for use around CRTs and other magnetically sensitive equipment?
Yes, but not with a lot of CRT TVs. - What is the efficiency rating?
The B-100 efficiency is rated at 90dB @ 2.83 / 1m. - What is the frequency range?
The speakers have a frequency range of 64Hz-23KHz ± 3dB. - Will they work with Alexa?
This depends on the receiver to which these speakers are connected. - How many Watts per channel are these speakers?
Each speaker has a wattage of 85 watts at 8 ohms. - Can these speakers be mounted on a stand?
Yes, these speakers can be mounted on a stand. - Can these speakers be mounted on a stand?
Yes, they come with grills that attach to the front. - Does our front cover include?
Yes, the front covers are included.