Kingstar TB39 Smart Watch User Manual
Power on/off
Power on: At “OFF” state, press and hold the button for 3 seconds to turn on smart watch.
(If failed, pls charge smart watch then power on again).
Power off: At “ON” state, press and hold the button for 3 seconds to turn off smart watch.
Download and install BT APP
The smart watch have to be connected by BT with mobile phone.
Pls install BT APP on mobile phone before use. Then connect smart watch and smart phone by BT, smart watch data will be transmitted and displayed on APP.
Scan the below QR code to download and install the corresponding app according to your phone.
How to connect smart watch to your smart phone by BT?
*Connect the second BT:eWatch audio:
In the dial interface (Shown by Figure 1), slide down to enter the notification bar (Figure 2), select the BT icon in the upper left corner to open (Blue icon means open e Watch audio, grey icon means off e Watch audio), shown by figure 2:
Figure : 1
Figure : 2
FCC INSTRUCTION:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Documents / Resources
 |
Kingstar TB39 Smart Watch [pdf] User Manual 2BOIQ-TB39, 2BOIQTB39, TB39 Smart Watch, TB39, Smart Watch, Watch |
