Keyhole Hovering Panel Installation Guide

Keyhole Hovering Panel

Instructions for installing the Keyhole hovering panel into a compatible piano shell.

Tools Needed

• Required tools ­ ¼” hex head driver
• Recommended tools (nut driver above not necessary with these tools) ­ drill driver, ¼” extension rod, ¼” hex bit

Instructions

• Note on 50-inch and larger models: you may need to remove the upright supports to allow the panel to fit/slide into the opening on the front of the piano.
• Prepare the panel by attaching the hardware as shown.
• The piano is carefully positioned upside down as shown [and with the sides open if TurnKey], and the panel into position.
• The insert is the same size as the rim opening, so line up the panel to match.
• Use [the supplied] ⅜” long hex head screws to anchor each bracket to the rim.