Mechanical Keyboard
User Guide
If you are a Windows user, please find the appropriate keycaps in the box, then follow the instructions below to find and replace the following keycaps.
Quick Start Guide
Switch To The Right System
Please make sure the system toggle on the top center has been switched to the same system as your computer’s operating system.
The VIA Key Rernapping Software
Please visit caniusevia.com to download the latest VIA software to remap the keys. If the VIA software cannot recognize your keyboard, please reach out to our support to get the instruction.
V/A
The Layers
There are five layers of key settings on the keyboard.
Layer 0 is for the Mac system.
Layer 1 is for the Windows system.
Layer 2 is for the Mac Multimedia keys.
Layer 3 is for the Windows Multimedia keys.
Layer 4 is for the Function keys.
If your system toggle is switched to Mac, then layer 0 will be activated
If your system toggle is switched to Windows, then layer 1 will be activated.
Multimedia Key and Function Key.
In order to get Multimedia Key, you need to press only and 
In order to get Function Key, you need to press fn2 and 
Key. Key.
The Backlight
Adjust The Backlight Brightness
Adjust The Backlight Speed
Warranty
The keyboard is highly customizable and easy to be rebuilt. If anything goes wrong with any of the keyboard components of the keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard.
Watch The Building Tutorial On Our Website
If you are building the keyboard for the first time, we highly recommend you watch the building tutorial video on our website first, then start building the keyboard yourself.
Factory Reset
Troubleshooting? Don’t know what’s going on with the keyboard?
- Try factory reset by pressing fnl +J +Z (for 4 seconds).
- Download the right firmware for your keyboard from our website. Remove the power cable from the keyboard.
- Remove the space bar keycap to find the reset button on the PCB.
- Hold the reset key while plugging in the power cable and then release the reset key. The keyboard now will enter DFU mode.
- Flash the firmware with the QMK Toolbox.
- Factory reset the keyboard again by pressing fnl + J + Z (for 4 seconds).
* Step by step guide can be found on our website.
Not Happy
support@keychron.com
Documents / Resources
 |
Keychron Q8 Mechanical Keyboard [pdf] User Guide Q8 Mechanical Keyboard, Q8, Mechanical Keyboard, Keyboard |
