Keychron Q5 Mechanical Keyboard

INSTRUCTIONS

1. Switch To The Right System
   Please make sure the system toggle on the top left corner has been switched to the same system as your computer’s operating system.
2. The VIA Key Remapping Software
   Please visit caniusevia.com to download thelatest VIA software to remap the keys. If the VIA software cannot recognize your keyboard, please reach out to our support to get the instruction.
3. The Layers
   1. There are four layers of key settings on the keyboard. The layer O and layer 1 are for the Mac system. The layer 2 and layer 3 are for the Windows system.
   2. If your system toggle is switched to Mac, then the layer O will be activated.
   3. If your system toggle is switched to Windows, then the layer 2 will be activated. Remember that if you are using it in Windows mode, please make changes to the layer 2 instead of the top layer ( the layer O ). This is a common mistake people are making
4. The Backlight
   Press fn + Q to change the lighting effectPress fn + tab to turn the backlight on/off
5. Adjust The Backlight Brightness
   • fn + W to increase the backlight brightness
   • fn + S to decrease the backlight brightness
6. Warranty 
   The keyboard is highly customizable and easy to be rebuilt. If anything goes wrong with any of the keyboard components of keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard
7. Watch The Building Tutorial On Our Website
   If you are building the keyboard for the first time, we highly recommend you watch the building tutorial video on our website first, then start building the keyboard yourself
8. Factory Reset 
   Troubleshooting? Don’t know what’s going on with the keyboard?
   1. Try factory reset by pressing fn + J +Z (for 4 seconds)
   2. Download the right firmware for your keyboard from our website. Remove the power cable from the keyboard.
   3. Remove the space bar keycap to find the reset button on the PCB.
   4. Hold the reset key while plugging in the power cable and then release the reset key. The keyboard now will enter DFU mode.
   5. Flash the firmware with the QMK Toolbox.
   6. Factory reset the keyboard again by pressing fn + J + Z (for 4 seconds)
      Note: Step by step guide can be found on our website

Support@keychron.com

Documents / Resources

	Keychron Q5 Mechanical Keyboard [pdf] Owner's Manual Q5, Mechanical Keyboard, Q5 Mechanical Keyboard, Keyboard
	Keychron Q5 Mechanical Keyboard [pdf] User Guide Q5, Mechanical Keyboard, Q5 Mechanical Keyboard, Keyboard

References

• User Manual