Keychron-LOGO

Keychron K17 Pro Wireless Custom Mechanical Keyboard

Keychron K17 Pro Wireless Custom Mechanical Keyboard-PRODUCT

If you are a Windows user, please find the appropriate keycaps in the box, then follow the instructions below to find and replace the following keycaps.

Quick Start Guide

  1. Switch To The Right System
    Please make sure the system toggle on the top left corner has been switched to the same system as your computer’s operating system.

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG2

  2. Connect Bluetooth
    Press fn + 1 (for4 seconds) and pair with device named Keychron K17 Pro.

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG2

  3. Connect Cable

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG4

  4. The VIA Key Remapping Software
    Please visit usevia.app to use the online VIA software to remap the keys.
    If the VIA cannot recognize your keyboard, please reach our support to get the instruction.
    “‘The online VIA software can only run on the latest version of Chrome, Edge, and Opera browsers yet. “‘VIA only works when the keyboard is connected by wire to the computer.

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG5

  5. The Layers

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG6

  6. The Backlight

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG7

  7. Adjust The Backlight Brightness

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG9

  8. Adjust The Backlight Speed

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG10

  9. Watch The Building Tutorial On Our Website
    If you are building the keyboard for the first time, we highly recommend you watch the building tutorial video on our website first, then start building the keyboard yourself.

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG12

  10. Factory Reset

    Keychron K17 Pro Wireless Custom Mechanical Keyboard-FIG13

Troubleshooting? Don’t know what’s going on with the keyboard?

  1. Plug in the power cable and switch the keyboard to Cable mode.
  2. Factory reset the keyboard by pressing fn + J + Z (for 4 seconds).
  3. Download the right firmware and QMK Toolbox from our website.
  4. Switch the keyboard to OFF mode and remove the space bar keycap to find the reset button on the PCB.
  5. Hold the reset key first, then switch the keyboard to Cable mode.
    Release the reset key, and the keyboard will now enter DFU mode.
  6. Flash the firmware with the QMK Toolbox.
  7. Factory reset the keyboard again by pressing fn + J+ Z (for 4 seconds).
    * Step by step guide can be found on our website.

Documents / Resources

Keychron K17 Pro Wireless Custom Mechanical Keyboard [pdf] User Guide
K17 Pro Wireless Custom Mechanical Keyboard, K17 Pro, Wireless Custom Mechanical Keyboard, Custom Mechanical Keyboard, Mechanical Keyboard, Keyboard

References

Leave a comment

Your email address will not be published. Required fields are marked *