Kessil-LOGO

Kessil W2K DMX Setting Box

Kessil-W2K-DMX-Setting-Box-PRODUCT

INSTALLATION

Kessil-W2K-DMX-Setting-Box-FIG1

  1. Connect OUTPUT port and W2K unit using RJ45 cable.
  2. When connected, press and hold knob for 5 sec to turn on and enable editing. To change the DMX address, press the knob 2x. The DMX address will begin flashing. Turn the knob to adjust the DMX address, and press knob 1x to confirm.
  3. Once the DMX address has been adjusted, remove the W2K DMX Setting box.

W2K Amazon Sun (8-bit mode) W2K Tuna Light Blue (8-bit mode)

DMX Address Function DMX Address Function
1 Intensity 0%-100% 1 Intensity 0%-100%
2 CCT 4000K-6500K 2 CCT 8000K-14000K

Fan Mode

  1. Press knob 6x to entered fan mode, turn knob to adjust mode, press again to confirm.

Kessil-W2K-DMX-Setting-Box-FIG2

Fan Speed Options

1689 Regatta Blvd., Richmond, CA 94804 | Kessil@Kessil.com | 510-620-5250

Documents / Resources

Kessil W2K DMX Setting Box [pdf] User Guide
W2K DMX Setting Box, W2K, DMX Setting Box, Setting Box, Box

References

Leave a comment

Your email address will not be published. Required fields are marked *