Keeson Technology RC304D Remote Control User Guide

Remote Control

Operating Instructions

• Head Up: Press and hold the HEAD UP button of the remote. The head actuator moves out and will stop when released.
• Head Down: Press and hold the HEAD DOWN button of the remote. The head actuator moves in and will stop when released.
• Foot Up: Press and hold the FOOT UP button of the remote. The foot actuator moves out and will stop when released.
• Foot Down: Press and hold the FOOT DOWN button of the remote. The foot actuator moves in and will stop when released.
• Lumbar Up: Press and hold the LUMBAR UP button of the remote. The lumbar actuator moves out and will stop when released.
• Lumbar Down: Press and hold the LUMBAR DOWN button of the remote. The lumbar actuator moves in and will stop when released.
• Underbed Light: Click the Underbed light button to toggle the light under the bed on or off.
• Massage Head: Click the MASSAGE HEAD button to cycle the head massage motor intensity through levels 0-1-2-3.
• Massage Foot: Click the MASSAGE FOOT button to cycle the foot massage motor intensity through levels 0-1-2-3.
• Massage Timer: If the massage motors are inactive, this button is disabled. If the massage motors are active, click this button to switch the massage timer setting; switching the timer to 0 turns off the massage.
• Double Click to FlatDouble-click this button (within approximately 0.5 seconds) to lower the head, feet, waist, and headtop motors simultaneously. Press any button during operation to stop movement immediately.
• Zero G: Click the ZG button to move the bed to the Zero Gravity position. Click any button during movement to stop the action.
• Memory Position: Click the Memory Position button to automatically adjust the bed to your saved position.
• Anti-snore Mode: Press this button to run the head and foot actuators to the designated Anti-snore position simultaneously. Action stops when any button is pressed. This position can be customized.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC RF Exposure InformationThe device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

ISED RSS WarningThis device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.