KDD-757 Headset and Controller Stand For Desk
Features
- Multifunctional Holder
- 2 Controllers and 1 Headset can be placed on the upper part, 3 grooves of different widths are installed on the front, which can hold iPad, Switch Console and mobile phone. It is multifunctional and very practical.
- Space-Saving
- This holder for desk can help you easily store controllers, iPad, Switch Console and mobile phone, and can also protect your items from damage due to messy placement, and keep the room tidy and orderly.
- Proper Design
- The controller holder is pasted with rubber to prevent from slipping off. The front part of the base is also covered with rubber to prevent your machine from slipping out when it is leaning against it. The new design of organizing cables makes your desktop tidy and orderly.
Package Includes
- 1 x bottom plate
- 2 x middle part rods
- 2 x curved boards
- 6 x screws
- 2 x lower part rods
- 2 x upper part rods
- 1 x small board
- 1 x Screwdriver
Installation Steps
- Step 1: Confirm that all parts are included, including a bottom plate, 2 lower part rods, 2 middle part rods, 2 upper part rods, 2 curved boards, 1 small board, 6 screws, 1 screwdriver.
- Step 2: Take out the bottom plate, 2 lower part rods and 2 screws. Use screws to connect the two rods to the bottom plate. Please pay attention to distinguish the top and bottom of the rods. The end with the smaller hole is connected to the bottom plate.
- Step 3: Take out a curved board, place it on the rod, and align the hole on the board with the hole on the rod.
- Step 4: Take out 2 middle part rods, screw the helical end into the holes of the curved boards and of the lower rod to fix the three parts.(You can use the included screwdriver to pass through the small hole of the middle rod to tighten it for more stability)
- Step 5: Take out the second curved board, align it with the holes of the middle part rods, and then take out 2 upper part rods, screw the helical end into the holes of the curved boards, and of the middle part rods to fix the parts.
- Step 6: Place the small board on the top, align it with the holes of the upper part rods, and fix the two parts with the remaining two screws.
CONTACT INFORMATION
24-Hour Customer Service
- If you have any issues, please contact KDD Customer Service at Contact@KDDservice.com for help.
Contact Us
- Email: Contact@KDDservice.com
- Instagram: https://www.instagram.com/kddstoreofficial/
- Facebook: https://www.facebook.com/KDDstoreofficial
Documents / Resources
 |
KDD KDD-757 Headset and Controller Stand For Desk [pdf] User Manual KDD-757, KDD-757 Headset and Controller Stand For Desk, KDD-757, Headset and Controller Stand For Desk, Controller Stand For Desk, Stand For Desk, For Desk, Desk |
