KASYPHE Universal Rear Camera Mounting Bracket
Overview
This manual explains how to install a rear camera by selecting an installation position and angle, securing it with screws through the mounting bracket, and stabilizing it on the rear window using double-sided tape.
Specifications
| Specification | Details |
|---|---|
| Product Type | Universal Rear Camera Mounting Bracket |
| Application | Vehicle rear-view camera installation |
| Compatibility | Suitable for many aftermarket backup cameras |
| Mounting Type | Vehicle body or license plate area mounting |
| Material | Durable metal or reinforced automotive-grade material |
| Adjustment Type | Adjustable camera angle positioning |
| Installation Method | Screw or bolt mounting depending on vehicle design |
| Finish | Corrosion-resistant surface coating |
| Usage | Parking assistance and rear visibility improvement |
| Vehicle Compatibility | Universal fit for cars, SUVs, trucks, and other vehicles |
Quick Setup
- Place the rear camera in the direction shown, ensure the installation position and angle, and choose a suitable installation position from the 3 fixing slots.
- Pass the screws through the camera metal sheet and the bracket from bottom to top as shown, then tighten the screws.
- Recommended vehicle installation location: choose the upper position in the middle of the rear windshield, and wipe the glass with a cleaning cloth.
- Peel off the double-sided tape and stick it on the rear window glass at an angle as shown; after confirming the position, press a few times to stabilize the stand.
Instruction
- Place the rear camera in the direction as shown in the figure, sure the installation position and angle, and select a suitable installation position from the 3 fixing slots.
- Pass the screws through the camera metal sheet and bracket from bottom to top as shown in the figure, and tighten them.
- The installation position on the car is recommended to choose the upper position in the middle of the rear windshield, and wipe the glass with a cleaning cloth.
- Peel off the double-sided tape and stick it on the rear window glass at an angle as shown in the picture. After confirming the position, press a few times to stabilize the stand.
Troubleshooting
- If the camera position feels unstable after applying the tape, press it several times after confirming the position to stabilize the stand.
- If adhesion is poor, wipe the rear window glass with a cleaning cloth before applying the double-sided tape.
Documents / Resources
 | Universal Rear Camera Mounting Bracket |
References
- User Manualmanual.tools
Published: August 3, 2026
Updated: August 5, 2026