Karlik DRO-3 Electronic Lighting Controller Mechanism
Characteristics of the electronic dimmer push-rotary mechanism for use with 1-10V voltage-controlled power supply unit
Electronic push-rotary dimmer designed to switch on and off and regulate the light intensity:
- LED lighting powered by dimmable LED power supplies controlled by 1-10V,
- 12V halogens powered by dimmable electronic transformers controlled by 1-10V,
- fluorescent lamps powered by dimmable electronic ballasts controlled by 1-10V.
A potentiometer with a switch is used to adjust the light level. The controller is equipped with short-circuit protection. The system enables intelligent control of lighting systems, providing comfort, convenience, and economy in use. In this way, it increases daily savings in electricity, the consumption of which is proportional to the lighting level.
Technical data
Warranty terms
The guarantee is provided for a term of twelve months from the date of purchase. The defective controller must be delivered to the producer or to the seller with a purchase document. The guarantee does not cover the fuse exchange, mechanical damage, damages raised by self-repair or improper use.
The warranty period shall be extended by the duration of the repair.
Warning! The protection class of the shield
The installation must be carried out by a qualified person at de-energized voltage and must comply with national safety standards. In order to maintain Class II protection, the user must be prevented from accessing the rear parts of the installation.
Installation
- Switch off the main fuses of the home installation.
- Dismantle the control key, then unscrew the nut, rand emove the washer and the dimmer adapter with the intermediate frame (see page 3 – components).
- Connect the wires to the connection terminals according to the wiring diagram.
- Install the dimmer module in the installation box using the box mounting screws or the metal claws included with the controller.
- Install the controller components in the following order: external frame, intermediate frame, adapter and washer.
- Screw in the nut, then mount the control key.
- Switch on the main fuses of the home installation and perform a test run.
The electric connection scheme of the electronic lightning controller
Warning!
The product is compatible with DECO / MINI surface-mounted folding boxes. In order to properly install the lighting regulator in the box, unscrew the metal claws located at the mechanism.
Components of the electronic lightning controller with push and rotary buttons for LED lamps
Installation instructions for electronic light controller mechanism in multiple frames
- First, install the electronic light control mechanism in the mounting box. The other adjacent mechanisms are installed so that the “dovetails”(1) (if any) overlap the central plate of the controller (2).
- The distance between the central frame of the dimmer and the adjacent products should be about 1 mm.
Karlik Elektrotechnik Sp. z o. o. I ul. Wrzesinska 29 | 62-330 Nekla I tel. +48 61 437 34 00 1 e-mail: karlik@karlik.pl | www.karlik.pl
Documents / Resources
 |
Karlik DRO-3 Electronic Lighting Controller Mechanism [pdf] User Manual DRO-3, DRO-3 Electronic Lighting Controller Mechanism, DRO-3, Electronic Lighting Controller Mechanism, Lighting Controller Mechanism, Controller Mechanism, Mechanism |
