juno T286L Trac-Master Flat Back Cylinder LED Trac Head with TEK Adapter Instruction Manual
INSTALLATION INSTRUCTIONS
WARNING: For your safety, read and understand instructions completely before starting installation.
Note: Use with non-Juno fixtures voids Juno warranty.
Installation Instructions for T283L/T285L/T286L Accessories
- Step 1: Remove all items from accessory packaging.
- Step 2: 3 set screws are required for installation.
Place up to 2 accessory media in between the fixture and accessory holder, snoot, or barn door.
(See T283L/T285L/T286L spec sheet for compatible accessory media). - Step 3: Line up the accessory holder, snoot, or barn door so that the set screws will fasten to the fixture bezel.
- Step 4: Use the provided Allen wrench to tighten all 3 set screws until you cannot pull off the accessory.
Caution: Do not over-tighten, however pull lightly on the accessory to make sure it is snug, and will not come off the fixture.
Note: Lining up the accessory holders to the fixture bezel is important due to when the set screws are installed and tightened, they will leave a mark.
- Figure 1: External Accessory Holder:
T770BL, T770SL, T770WH
- Figure 2: External Snoot/Accessory Holder:
T5788BL
- Figure 3: External Barn Door/Accessory Holder:
T5774BL*
Cannot be used with T579BL, Cube Cell louver
WARRANTY
5-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Technical Services Phone 888-387-2212
CUSTOMER SUPPORT
1300 S. Wolf Road Des Plaines, IL 60018
Phone: 800-323-5068
Visit us at: www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc Rev 3/22 P4218
Documents / Resources
 |
juno T286L Trac-Master Flat Back Cylinder LED Trac Head with TEK Adapter [pdf] Instruction Manual T286L Trac-Master Flat Back Cylinder LED Trac Head with TEK Adapter, T286L, Trac-Master Flat Back Cylinder LED Trac Head with TEK Adapter, Flat Back Cylinder LED Trac Head, Cylinder LED Trac Head, LED Trac Head, Trac Head, Head |
