JUNHOM NK-8006 Car Push Start Keyless Entry Security System
Technical parameters of remote control
- Transmission frequency: 433.92MHz
- Battery model: 3V button lithium battery
Operation Instructions of Remote Control
- Arm/Lock Button: Press and release 1times, the alarm arms and doors lock
- Disarm/Unlock Button: Press and release 1times, the alarm disarms and doors unlock
- Remote Start Button: press hold down the button for 3 second to activates the remote starter
- Trunk Release Button: The Trunk opens when this button is pressed for two twice.
- Silent Arm Button: Press and release 1times , enter silent arm & silent lock/unlock status.
FCC Statement
FCC Warning Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet the general RF exposure requirement
FAQ
- Q: How do I replace the battery in the remote control?
- A: To replace the battery, open the back cover of the remote control and carefully remove the old battery. Insert a new 3V button lithium battery in the correct orientation and close the back cover securely.
- Q: What should I do if the remote control is not working?
- A: If the remote control is not working, check if the battery needs replacement. If the issue persists, contact customer support for further assistance.
Documents / Resources
 |
JUNHOM NK-8006 Car Push Start Keyless Entry Security System [pdf] Instructions 2BMFR-NK-8006, 2BMFRNK8006, NK-8006 Car Push Start Keyless Entry Security System, NK-8006, Car Push Start Keyless Entry Security System, Start Keyless Entry Security System, Keyless Entry Security System, Entry Security System, Security System |