JONSBO TK-0 Computer Case Installation Guide

JONSBO TK-0 Computer Case

Package Content

Connectors

The connector diagram only shows the line sequence relationship. Please refer to the actual product for functions

Parts Diagram

Parts

1. Aluminum top cover
2. Aluminum side panels
3. Chassis
4. Air filter
5. Glass panel
6. PCI E card strip
7. HDD bracket
8. Power rack

Installation Guide

1. Remove aluminum top cover, glass and aluminum side panels before installing hardwareRemove aluminum top cover, glass and aluminum side panels before installing hardware
2. PSU installation
3. Remove external cover The motherboard is placed in the area shown and locked with screws.
4. Fan bracket installation Top plate 120mm*l or 140mm*l Bottom plate 120mm*l or 140mm*l Rear plate 90mm*2
5. Graphics card installation
   1. Remove the PCIE card strip.
   2. Insert the graphics card into the card slot and lock it with screws.
6. HDD Installation
   1. Remove the hard drive bracket and install the HDD hard drive on the bracket.
   2. Install the assembled hard disk bracket on the chassis with screws.
7. SSD hard disk installation
   1.  Remove the HDD bracket, install the SSD t the bracket with screws and rubber grommets
   2. Insert the HDD to tHe bracket to the correspond slots, push in to secure
   3. Install the HDD bracket back to chassis, and secure with screws
8. Install related parts Install aluminum roof, glass and aluminum side panels
9. Chassis horizontal installation
   1. Remove the base plate feet and side plate screws.
   2. Place the foot base on one side of the side plate and lock it with the corresponding screws.

Dongguan Sibositong Industrial Co., Ltd.
No.5, Xinglong Lu, Sanzhong Village, Qingxi Town, Dongguan City, Guangdong Province, 523651, China
© 2023 Dongguan Sibositong Industrial Co., Ltd. All right reserved. Specifications are subject to change without prior notice. Some trademark may be claimed as the property of others.