JONES STEPHENS C77485LF PlumBite 1-1/4 in. Push-to-Connect Fitting Removal Tool

To Remove Pipe/Tubing from Fitting

1. Follow direction imprint on the side of the removal tool: Flat Side of Tool – on the pipe/tubing side of the collar. Beveled Side of Tool – on the fitting side of the collar.
2. Slide removal tool over PlumBite® collar.
3. With tool firmly pressed over collar, slide pipe/tubing out of PlumBite® fitting. Note: The PlumBite® fitting can be reused after disconnection.

Documents / Resources

JONES STEPHENS C77485LF PlumBite 1-1/4 in. Push-to-Connect Fitting Removal Tool [pdf] Instructions C77485LF, PlumBite 1-1 4 in. Push-to-Connect Fitting Removal Tool, C77485LF PlumBite 1-1 4 in. Push-to-Connect Fitting Removal Tool

References

• User Manual