JBC-logo

JBC SADS Tool Holders for Stands

JBC-SADS-Tool-Holders-for-Stands-pro

Packing List

The following items are included:

  • Tool Holder …………… 1 unit
  • Manual ………………….. 1 unit

Replacement

Before carrying out maintenance, always unplug the tool. Allow the equipment to cool down. Be sure that the power supply is disconnected before changing any spare part.

Changing the Tool Holder

  • Remove the locking knob (1). Separate the tool holder from the stand and remove the holder screw (2).JBC-SADS-Tool-Holders-for-Stands-1
  • Carefully move the tool holder sidewards until the cable* comes out (3). Place the new tool holder following the disassembling steps conversely.JBC-SADS-Tool-Holders-for-Stands-2

SpecificationsJBC-SADS-Tool-Holders-for-Stands-3

Documents / Resources

JBC SADS Tool Holders for Stands [pdf] Instruction Manual
SADS, SAPS, SAMS, SHTS, Tool Holders for Stands, Tool Holders

References

Leave a comment

Your email address will not be published. Required fields are marked *