JBC DT10 Wool Filter Prefilter

Product Information

Specifications:

• Model: DT530
• Filters Included: DT10 Wool Filter, DT11 Brass-Wool Prefilter
• Filter Quantity: 10 filters per box

Product Usage Instructions

Filter Replacement:

1. Hold down the tool with one hand onto the stand and grasp the suction hose at the point where it meets the hose connector.
2. Pull upward to undock the solder-collector group from the heating element.
3. Detach the hose connector from the solder collector by gently pulling both in opposite directions.
4. If the solder collector is too hot, use the heat-resistant gripper provided with the tool.
5. Remove the frontal gasket by pulling it out.
6. Use the cleaning brush provided to push the worn filters and the rearward gasket out of the cylinder.
7. Replace the worn filters with new ones.
8. Fit the rearward gasket onto the cylinder so that the wool filter lays on the same side as the rearward gasket.
9. Push both filters as far as possible against the rearward gasket using the cleaning brush.
10. Fit the front gasket onto the glass cylinder and reassemble the solder collector to the hose connector.
11. Reassemble the whole collector group to the desoldering iron.

FAQ

• Q: How often should I replace the filters?
  • A: It is recommended to replace the filters when they appear worn or clogged to maintain optimal performance.
• Q: Can I use any other filters with this product?
  • A: It is advisable to use only DT10 Wool Filter or DT11 Brass-Wool Prefilter designed for DT530 to ensure compatibility and effectiveness.

Packing List

One of the following sets is included depending on the purchased reference:

DT10

• Wool Filter …. 1 box
• Contains 10 filters

DT11

• Brass-Wool
• Prefilter …….. 1 box
• Contains 10 filters

Filter Replacement

Be careful when manipulating the tool. The metal and glass parts may be hot.

• Hold down the tool with one hand onto the stand (1) grasp the suction hose at the point where it meets the hose connector and pull upward (2) to undock the solder-collector group from the heating element.
• Detach the hose connector from the solder collector by gently pulling both in opposite directions (3). If the solder collector is too hot, use the heat-resistant gripper provided with the tool.
• Then remove the frontal gasket by pulling it out as well (4). Use the cleaning brush provided with the tool to push the worn filters and the rearward gasket out of the cylinder (5). Replace the worn filters and slide back in the new ones.
• Fit the rearward gasket onto the cylinder (6) so that the wool filter lays on the same side as the rearward gasket. Push both filters as far as possible against the rearward gasket using the cleaning brush (7).

Fit the front gasket onto the glass cylinder and reassemble the solder collector to the hose connector. Finally, reassemble the whole collector group to the desoldering iron.

www.jbctools.com

Documents / Resources

JBC DT10 Wool Filter Prefilter [pdf] Instruction Manual DT10 Wool Filter Prefilter, DT10, Wool Filter Prefilter, Filter Prefilter, Prefilter

References

• User Manual