JAMARA Q7 Standard Servo Specs
General information
JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.
Certificate of Conformity
Hereby JAMARA e.K. declares that the product Q7 Standard, Nr. 033215“ complies with Directive 2014/30/EU and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: www.jamara-shop.com/Conformity
Technical data
- Nominal tension 4,8V ~ 6,0 V
- Torque (kg/cm) 5,6 kg/cm (4,8 V) 6,2 kg/cm (6,0 V)
- Transit time (Sec./60°) 0,14 Sek. (4,8 V) 0,12 Sek. (6,0 V)
- Gear Plastic
- Ball bearing 2BB
- Dimensionis (mm) 51 x 40,5 x 44,3
- Weight (g) 48 g
All rights reserved. Copyright JAMARA e.K. 2024 Copying or reproduction in whole or part, only with the expressed permission of JAMARA e.K.
Disposal restrictions
Electrical appliances must not be disposed of in domestic waste and must be disposedof separately. You are obliged to take outthe batteries, if possible, and to dispose of the electrical equipment at the communal collection points. Should personal data be stored on the electrical appliance you must remove them by yourself.
Service centre
- Reitter Modellbau Versand, Patricia Reitter, Degerfeldstrasse 11, 72461 Albstadt Tel. 07432 9802700, Fax 07432 2009594, info@modellbauversand.de, www.modellbauversan
- info@jamara.com
- www.jamara.com
- Service – Tel. +49 (0) 75 65/94 12-777
- service@jamara.com
FAQs
Q: What should I do if the product is not functioning correctly?
A: If you encounter any issues with the product’s performance, refer to the troubleshooting section of the user manual or contact customer support for assistance.
Q: Can I use a charger with a voltage higher than 6.0V?
A: It is not recommended to use a charger with a voltage higher than the specified range (4.8V – 6.0V) as it may damage the product.
Documents / Resources
 |
JAMARA Q7 Standard Servo Specs [pdf] Instructions 033215, Q7 Standard Servo Specs, Q7, Standard Servo Specs, Servo Specs, Specs |