FOTING 12" Sand Filter Pump Instruction Manual

1. 安全情報

Please read and understand all safety warnings and instructions before installing, operating, or performing maintenance on this product. Failure to follow these instructions could result in serious injury or property damage.

• This pump has been evaluated for use with water only. Do not use with other liquids.
• To reduce risk of electric shock, do not plug into power while standing on a wet or damp 表面。
• To reduce risk of electric shock, connect only to a properly grounded grounding-type receptacle.
• 感電の危険を軽減するため、漏電遮断器 (GFCI) によって保護された回路にのみ設置してください。
• Always disconnect power before servicing the pump or filter system.
• Keep children and unauthorized persons away from the pump and pool area during operation.

2.製品オーバーview

The FOTING 12" Sand Filter Pump is designed to provide efficient and thorough filtration for above-ground pools up to 8000 gallons, ensuring crystal-clear water. It features a robust 1/2 HP motor and a versatile 6-way valve.

Image: The FOTING 12" Sand Filter Pump system, including the blue filter tank, black pump, pressure gauge, hoses, clamps, and filter balls.

主な特徴:

• Customized Filtration: Choose from 10 time settings and single or continuous cycles for efficient operation.
• 最大流量： Impressive 3000 GPH flow rate, ideal for pools up to 8000 gallons.
• 耐久性の向上: Boasts a 44 lb sand capacity for long-lasting, efficient filtration.
• 卓越したパフォーマンス: Equipped with a robust 1/2 HP motor and 27 ft maximum head for optimal water circulation.
• 6方弁: Adaptable for various filtration needs, ensuring a pristine pool environment.

含まれるコンポーネント:

Image: A detailed diagram listing and illustrating the components included with the FOTING sand filter pump, along with its overall dimensions.

• ユーザーマニュアル
• 保証書
• 圧力計
• Drain Piece
• Pair of Flange Clamps
• Oリング
• レンチ
• NPT 1-1/2 Female Connectors
• ガムテープ
• ホースClamps
• サンドカバー
• Sylphon Bellows
• フィルターアセンブリ
• ベース
• Valve Head Assembly
• シリンダー
• ネジとナット

3. セットアップ

Proper setup is crucial for the optimal performance and longevity of your FOTING sand filter pump. Follow these steps carefully.

組み立て手順:

1. Place the filter tank on a firm, level surface near your pool.
2. Install the pump onto the base, ensuring it is securely fastened.
3. Connect the pump to the filter tank using the provided hoses and clamps. 漏れを防ぐために、すべての接続がしっかりと締まっていることを確認してください。
4. Attach the 6-way valve head assembly to the top of the filter tank.
5. Connect the pool hoses to the appropriate inlets and outlets on the pump and filter system.

Image: Illustration of the 1-1/2 inch pump hose connectors and hose adapters for connecting the filter system to an in/above ground pool.

フィルタータンクの充填：

Before operating, the filter tank must be filled with the appropriate filter media. This model is designed for sand or filter balls.

• 排水プラグがしっかりと閉まっていることを確認してください。
• Carefully add the recommended amount of filter sand (up to 44 lbs) or filter balls (200g included) into the tank.
• タンクに過剰に充填しないでください。

Image: The FOTING sand filter pump highlighting its large flow rate of 3000 GPH, suitable for 2800-8000 gallon pools, with a 12-inch/44 lbs sand capacity and built-in timer.

4. 操作手順

The FOTING sand filter pump features a 6-way valve for various functions and an intelligent timing system for automated operation.

6-Way Valve Functions:

The multi-port valve allows you to perform different operations by rotating the handle to the desired position. Always turn off the pump before changing valve positions.

Image: A visual guide to the 6-way valve, detailing each position and its corresponding function for pool water management.

1. フィルター： Normal filtering mode. Water passes through the filter media and returns to the pool.
2. バックウォッシュ： Reverses water flow through the filter to clean the filter media. Water is discharged to waste.
3. リンス： Used after backwashing to flush out any remaining debris from the filter and lines before returning to FILTER mode. Water is discharged to waste.
4. 無駄： Bypasses the filter and pumps water directly out of the pool to waste. Useful for lowering water level or vacuuming heavy debris.
5. 休業： Shuts off all flow to the filter and pump. Never use while the pump is running.
6. 循環： フィルターをバイパスし、水をプールに直接循環させます。ろ過せずに薬品を混ぜるのに便利です。

Intelligent Timing System:

The pump features a 24-hour dual-mode intelligent timing system, allowing you to set specific operating schedules.

Image: An illustration of the pump's control panel, detailing the two timing modes: Single Cycle Mode for a set duration and Continuous Cycle Mode for ongoing operation.

• シングルサイクルモード: Set a specific duration for the pump to run (e.g., 8 hours). The pump will run for the set time and then turn off.
• 連続サイクルモード: The pump will run continuously until manually turned off or the timer is reset.
• Refer to the control panel (image below) for setting the timer.

画像: クローズアップ view of the FOTING pump's control panel, showing the digital display for time settings and the power and mode selection buttons.

5. メンテナンス

Regular maintenance ensures the longevity and efficiency of your FOTING sand filter pump.

逆洗とすすぎ：

Backwash and rinse the filter regularly, especially when the pressure gauge reading increases by 5-10 PSI above its clean operating pressure, or when water flow to the pool decreases significantly.

• ポンプをオフにします。
• Set the 6-way valve to 'BACKWASH'.
• ポンプをオンにして、サイトグラス（ある場合）内の水が透明になるまで（通常 2 ～ 3 分）稼働させます。
• ポンプをオフにします。
• Set the 6-way valve to 'RINSE'.
• Turn on the pump and run for 30-60 seconds to flush the lines.
• ポンプをオフにします。
• Set the 6-way valve back to 'FILTER' for normal operation.

画像: クローズアップ view of the pressure gauge, which indicates the internal pressure of the filter system and helps determine when backwashing is needed.

フィルターメディアの交換:

Sand filter media typically needs replacement every 3-5 years, depending on usage and water quality. Filter balls may need cleaning or replacement more frequently based on their condition.

Image: A pyramid of white filter balls, indicating the type of filter media used in the system.

冬季：

Before freezing temperatures, drain all water from the pump, filter, and hoses. Store the pump and filter in a dry, protected area to prevent freeze damage.

6。 トラブルシューティング

If you encounter issues with your FOTING sand filter pump, refer to the common problems and solutions below.

Image: A visual comparison demonstrating the powerful filtering ability of the pump, showing a pool's water clarity before and after filtration.

7. 仕様

Detailed technical specifications for the FOTING 12" Sand Filter Pump (Model FT-CLP5502).

Image: The FOTING sand filter pump highlighting its large flow rate of 3000 GPH, suitable for 2800-8000 gallon pools, with a 12-inch/44 lbs sand capacity and built-in timer.

8. 保証とサポート

FOTING stands behind the quality of its products.

保証情報:

This FOTING sand filter pump is backed by a 3年間の保証 ご購入日から1年間。この保証は製造上の欠陥をカバーし、お客様の投資に対する安心を保証します。

カスタマーサポート:

For any questions, technical assistance, or warranty claims, please contact FOTING customer service. Refer to the warranty card included with your product for specific contact details or visit the official FOTING webサイト。

We are committed to providing excellent after-sales support to ensure your satisfaction.