BUNN BX スピードブリュークラシック 10カップコーヒーブリューワー 取扱説明書

1. はじめに

Welcome to the BUNN BX Speed Brew Classic 10-Cup Coffee Brewer. This manual provides essential information for the safe and efficient operation, maintenance, and care of your new coffee maker. The BUNN Speed Brew system is designed for quick brewing, utilizing an internal commercial-grade stainless steel hot water tank that keeps 70 ounces of water consistently hot, allowing for rapid brewing.

画像1：正面 view of the BUNN BX Speed Brew Classic 10-Cup Coffee Brewer.

2. 重要な安全情報

ご使用前に必ずすべての説明書をよくお読みください。この取扱説明書は、今後の参考のために保管してください。

• コード、プラグ、または機器を水やその他の液体に浸さないでください。
• いかなる機器も、子供が使用したり、子供の近くで使用したりする場合には、厳重な監視が必要です。
• 使用していないときや清掃する前には、コンセントからプラグを抜いてください。部品の取り付けや取り外し、および機器の清掃を行う前には、機器が冷めるまで待ってください。
• コードやプラグが損傷している機器、または機器が故障したり、何らかの損傷を受けたりした場合は、機器を操作しないでください。
• 機器メーカーが推奨していない付属品を使用すると、火災、感電、または人身事故につながる可能性があります。
• 屋外では使用しないでください。
• コードをテーブルやカウンターの端から垂らしたり、熱い表面に触れたりしないでください。
• 高温のガスバーナーや電気バーナーの上や近く、または加熱されたオーブンの中に置かないでください。
• 必ず最初にプラグを機器に接続し、次にコードを壁のコンセントに差し込んでください。取り外すには、いずれかのスイッチを「オフ」にしてから、プラグを壁のコンセントから抜いてください。
• 本来の用途以外には機器を使用しないでください。
• 可動部品との接触を避けてください。
• This appliance is built to North American Electrical Standards.

3. 箱の中身

Your BUNN BX Speed Brew Classic 10-Cup Coffee Brewer package includes:

• BUNN BX Speed Brew Classic Coffee Brewer Unit
• 漏斗
• ドリップフリーガラスカラフェ

Image 2: The main components of the coffee brewer.

4. セットアップ

Before first use, it is crucial to properly set up your coffee brewer to ensure optimal performance and safety.

1. 配置: Place the coffee brewer on a flat, stable surface near an electrical outlet.
2. 初期充填: The BUNN Speed Brew features an internal hot water tank. For the first use, fill the carafe with cold water and pour it into the top reservoir. Repeat this step until the internal tank is full (approximately 70 ounces or 2 liters).
3. 電源オン: Plug the brewer into a grounded electrical outlet. Turn on the main power switch (usually located on the side or back). The internal tank will begin heating the water to the optimal brewing temperature of 200°F (93°C). This process may take about 15-20 minutes for the first heating cycle.
4. プラグを差し込んでください: For the fastest brewing, it is recommended to keep the brewer plugged in and the internal tank heated at all times. This allows for instant brewing when you're ready.

ビデオ1: オーバーview of how the BUNN coffee maker works, including water filling and brewing initiation.

5. 操作手順

Once your BUNN Speed Brew is set up and the internal tank is heated, brewing coffee is a quick and simple process.

1. Prepare the Funnel: Place a BUNN-specific coffee filter (1/4 inch taller than standard filters) into the funnel. Add your desired amount of ground coffee to the filter.
2. Insert Funnel: Slide the funnel with coffee grounds into its designated slot in the brewer.
3. カラフェを置く場所: Ensure the empty glass carafe is placed securely on the warming plate beneath the funnel.
4. 水を加える： Open the lid of the top reservoir. Fill the carafe with the desired amount of cold water (e.g., 4 cups for 20 oz, up to 10 cups for 50 oz). Pour this cold water into the top reservoir.
5. 醸造開始: Close the lid of the top reservoir. This action will activate the brewing cycle, displacing the hot water from the internal tank over the coffee grounds.
6. 醸造時間: Your coffee will begin brewing almost immediately. A full 10-cup carafe typically brews in about 4 minutes. Smaller quantities, such as 20 oz for a travel mug, can brew in approximately 2 minutes.
7. Warmer Plate: The brewer features a switch-activated warmer plate to keep your coffee at an optimal serving temperature. Ensure the warmer switch is in the "ON" position if you wish to keep the coffee hot after brewing.

Image 3: Pouring cold water into the top reservoir to initiate brewing.

Image 4: Coffee dripping into the glass carafe during the brewing process.

Image 5: The exclusive drip-free carafe design ensures a clean pour.

6. メンテナンス

Regular cleaning and maintenance will prolong the life of your coffee brewer and ensure consistent coffee quality.

• 毎日の清掃: Wash the carafe and funnel with mild detergent and warm water after each use. Rinse thoroughly.
• 外装清掃: 醸造機の外側を広告で拭くamp 布。 研磨クリーナーや研磨パッドは使用しないでください。
• スケール除去： Over time, mineral deposits can build up in the internal hot water tank. Descale your brewer periodically (e.g., every 3-6 months, depending on water hardness) using a descaling solution or a mixture of white vinegar and water. Follow the descaling product's instructions carefully.

7。 トラブルシューティング

If you encounter issues with your BUNN BX Speed Brew, refer to the following common solutions:

• No Coffee Brews: Ensure the brewer is plugged in, the power switch is on, and the internal tank has had sufficient time to heat up. Check that the lid is fully closed after pouring water into the reservoir.
• Coffee is Not Hot Enough: Verify the warmer plate switch is in the "ON" position. Ensure the internal tank is always kept heated by keeping the unit plugged in.
• Coffee Grounds Overflow: Use BUNN-specific coffee filters, which are designed to be 1/4 inch taller than standard filters to prevent overflow, especially with finer grinds.
• スローブリューイング： If the brewer is consistently brewing slowly, it may indicate a mineral buildup in the internal tank. Refer to the descaling instructions in the Maintenance section.

8. 仕様

9. 保証とサポート

Your BUNN BX Speed Brew Classic 10-Cup Coffee Brewer comes with a 3年間保証 on all Speed Brew models. For any questions, troubleshooting assistance, or warranty claims, please contact the BUNN Customer Service Team. They are located in Springfield, IL, USA, and are available to take your calls and emails.

Refer to the product packaging or the official BUNN web最新の連絡先情報については、サイトをご覧ください。