BUNN VP17-3 Commercial Pourover Coffee Maker Instruction Manual

1. はじめに

The BUNN VP17-3 is a 12-cup low profile pourover commercial coffee maker designed for efficient and reliable coffee brewing. This model features three lower warmers to keep multiple decanters of coffee hot and ready for serving. Capable of brewing up to 3.8 gallons (14.4 liters) of coffee per hour, it is suitable for various commercial settings. Its stainless steel exterior ensures durability, and the SplashGard funnel enhances safety by deflecting hot liquids away from the user's hands. This instruction manual provides essential information for the safe and effective use of your BUNN VP17-3 coffee maker.

図1: 前面 view of the BUNN VP17-3 Commercial Pourover Coffee Maker.

2. 安全情報

Please read all safety instructions carefully before operating the appliance. Failure to follow these instructions may result in injury or damage to the product.

• 電気安全: This product is built to North American Electrical Standards (120 Volts). Ensure the appliance is connected to a properly protected circuit capable of the rated load. Do not use with extension cords. Follow all national and local electrical codes.
• 高温面： The coffee maker and its warmers contain hot liquids and surfaces. Exercise extreme caution to prevent burns. The SplashGard funnel is designed to deflect hot liquids, but direct contact with hot surfaces should be avoided.
• Hot Liquid Warning: Always remove the funnel slowly after brewing to avoid splashing hot liquid.
• 水位: Always fill the water tank before turning on the power to prevent damage to the heating element.
• メンテナンス： Disconnect the appliance from the power source before cleaning or performing any maintenance. Do not immerse the appliance in water.
• 子供たち： Keep children away from the appliance during operation and while it is hot.

図2：戻る view of the coffee maker showing electrical cord and warning labels.

3. セットアップ

The BUNN VP17-3 is a pourover model, meaning it does not require plumbing connections, offering complete portability. Follow these steps for initial setup:

1. 開梱: Carefully remove the coffee maker from its packaging. Inspect for any shipping damage.
2. 配置: Place the coffee maker on a stable, level surface. Ensure adequate clearance around the unit for ventilation and safe operation.
3. 電源接続: Plug the coffee maker into a grounded 120V AC outlet.
4. 初期充填: Before turning on the warmers or brewing, fill the internal water tank. Open the lid on top of the unit and pour cold, fresh water into the reservoir until it reaches the fill line (refer to Figure 3).
5. 予熱: Turn on the main power switch. Allow approximately 15-20 minutes for the water in the internal tank to heat to the optimal brewing temperature. The unit is ready when the "Ready" indicator light illuminates (if applicable, or when the heating cycle completes).

図3：上 view of the coffee maker, illustrating the water reservoir opening.

4. 操作

Operating the BUNN VP17-3 is straightforward. Ensure the unit is properly set up and pre-heated before brewing.

1. Prepare the Funnel: Place a BUNN coffee filter into the brew funnel. Add the desired amount of ground coffee into the filter.
2. Insert Funnel: Slide the brew funnel into the funnel rails beneath the spray head.
3. デキャンタを置く場所: Position an empty coffee decanter on the warmer plate directly below the brew funnel. The BUNN VP17-3 accommodates up to three decanters on its lower warmers (decanters sold separately).
4. 水を注ぐ: Open the lid on top of the coffee maker and slowly pour a full decanter of cold, fresh water into the water tank. The brewing cycle will begin automatically as the cold water displaces the hot water in the tank, forcing it through the coffee grounds.
5. 醸造工程: Hot coffee will begin to flow into the decanter. The brewing process for a full decanter typically takes a few minutes.
6. 盛り付け: Once brewing is complete, the coffee will remain hot on the warmer plate. You can brew additional decanters by repeating steps 1-4.
7. 安全上の注意: Always remove the brew funnel slowly after brewing to avoid hot liquid splashing.

図4: 前面 view of the coffee maker with decanters in place, ready for brewing.

5. メンテナンス

Regular cleaning and maintenance are crucial for the longevity and optimal performance of your BUNN VP17-3 coffee maker. Always unplug the unit before cleaning.

• 毎日の清掃:
  • Wash the brew funnel and decanters with mild detergent and warm water after each use. Rinse thoroughly.
  • コーヒーメーカーの外側を広告で拭きますamp 布で拭いてください。研磨剤入りの洗剤や研磨パッドはステンレスの表面を傷める可能性があるため、使用しないでください。
  • Clean the warmer plates to remove any spilled coffee.
• Decalcification (Regularly):

  Mineral deposits (calcification) can build up in the internal water tank, especially with hard water, affecting brewing performance and taste. Decalcify the unit regularly (e.g., monthly or as needed based on water hardness and usage). Follow the manufacturer's recommended decalcification procedure, typically involving a descaling solution or a vinegar solution. Ensure the unit is thoroughly rinsed after decalcification.

• ストレージ： If the machine is not used daily, it is recommended to drain the water thoroughly from the reservoir and leave it unplugged to prevent calcification or contamination.

図5：側面 view of the coffee maker, illustrating its compact design for easy cleaning access.

6。 トラブルシューティング

This section addresses common issues you might encounter with your BUNN VP17-3 coffee maker. For problems not listed here, contact customer support.

7. 仕様

Figure 6: Technical diagram showing the dimensions of the BUNN VP17-3 coffee maker.

8.保証とサポート

For specific warranty details and terms, please refer to the warranty card included with your product packaging or visit the official Bunn webサイトでご確認ください。保証請求に備えて購入証明書を保管してください。

For technical assistance, replacement parts, or service inquiries, please contact Bunn customer support. Contact information can typically be found on the Bunn webサイトまたは製品ドキュメントに記載されています。