User manual
1X2 SDI Splitter
JTD-178 | JTDSDI0102
Thank you for purchasing the J-Tech Digital JTDSDI0102. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference.
Introduction
The JTDSDI0102 splitter distributes 1 SDI, HD-SDI or 3G-SDI video source to 2 SDI/HD-SDI/3G-SDI displays simultaneously. This product features built-in automatic device identification and is compatible with SD-SDI, HD-SDI, 3G-SDI formats of SDI signal. The JTDSDI0104 supports 2.97Gbps bandwidth and lossless transmission over long distances.
Features
- 1 SDI input signal split to 2 SDI sink devices.
- Supports SD-SDI (270Mb/s) | HD-SDI(1.485Gb/s) | 3G-SDI(2.97Gb/s) video formats.
- Built-in cable equalization, clock recovery and drive.
- Supports resolutions up to 1920×1080@60Hz.
- Supports signal input and output distances of up to 984FT for SD signals, 656FT for HD signals and 328FT for 3G signals.
- Supports 5-12V wide voltage input.
Package
- 1×2 JTDSDI0102 Splitter —————————————————————- 1PCS
- 5V1A DC Power Supply Adapter ——————————————————- 1PCS
- Operation Manual ————————————————————————- 1PCS
Specifications
| 1. Frequency Bandwidth | 3Gbps |
| 2. SDI Splitter Input Ports | 1 x BNC Female input port |
| 3. SDI Splitter Output Ports | 2 x BNC Female output ports |
| 4. Power Supply | DC 5V 1A |
| 5. ESD Protection Human Body Model: | ± 8kV (air-gap discharge) ± 4kV (contact discharge) |
| 6. Dimensions (W x D x H) | 2.75in x 5.70in x 0.98in |
| 7. Weight | 350g |
| 8. Operating Temperature | 0°C ~ 40°C / 32°F ~ 104°F |
| 9. Storage Temperature | -20°C ~ 60°C / -4°F ~ 140°F |
| 10. Relative Humidity | 20 ~ 90% RH (Non-condensing) |
| 11. Power Consumption (Max) | 1.5W |
Operation Controls and Functions
Front Panel
- ON/OFF: Power on/off switch.
- POWER LED: This red LED illuminates when the device is connected to the power supply.
- LOCK LED: This red LED illuminates when the SDI signal is detected.
Rear Panel
- SDI INPUT: Use this port to connect the SDI source output from SDI Camera.
- SDI OUTPUT: Use these ports to connect the SDI displays or monitors with coaxial cable (RG6).
- DC 5V-12V: Plug the 5V or 12V DC power supply into the unit and connect the adapter to AC wall outlet.
Application Example
www.jtechdigital.com
Published by J-Tech Digital, Inc.
12803 Park One Drive
Sugar Land, TX 77478
Documents / Resources
 |
J-TECH DIGITAL JTD-178 1X2 SDI Splitter [pdf] User Manual JTD-178, JTDSDI0102, JTD-178 1X2 SDI Splitter, 1X2 SDI Splitter, SDI Splitter, Splitter |
